Viper 300+ Installation Manual page 19

Once the button has been pressed and released the correct number of times press it once more and hold it. After
a second, the siren will chirp to indicate what step you have accessed. For example, three chirps would indicate access
to the ignition controlled door lock feature.
4.
5.
For example, to program the arming mode from active to passive, press and release the Valet/program button once.
Then press and hold it. The siren will chirp once, indicating that the setting can now be changed. While holding the
Valet/program button, press the arm/disarm button on the transmitter. The siren will chirp twice to indicate that passive
arming has been programmed. If this is the desired setting, release the Valet /program button. If this is not the desired
setting, continue to hold the Valet /program button and press the arm/disarm button on the transmitter again. The siren
will chirp once indicating that active arming has been programmed. Once the desired setting has been selected,
release the Valet/program button.
You can advance from step to step by pressing and releasing the Valet/program button the number of times necessary
to get from the step you just programmed to the step you wish to access. If you just programmed the arm/disarm
chirps to off and you want to program passive locks, release the Valet/program button, press and release it twice to
step from feature two to feature four. Then press it once more and hold it. The unit will chirp four times to confirm that
you have accessed feature number four.
The Learn Routine ™ will be exited if:
• The ignition is turned on.
• The door is closed.
• The Valet ® button is pressed too many times.
• More than 15 seconds elapses between steps.
The siren will emit a long chirp when Learn Routine
© 1995,1997 Directed Electronics, Inc. Vista, CA
Transmit
While holding the Valet
button of the transmitter, to toggle between the one and two chirp
settings. The one-chirp settings are the factory defaults.
Release
The button can now be released.
®
/program button, use the arm/disarm
™ is exited.
19
N432 1-98.PM6