Clifford Concept 450 Installation Manual page 35

Note #5: PIN Programming
A PIN code can have one to four digits; each digit can be from 0-9.
N N O O T T E E : : A PIN code cannot begin with a zero.
Programming Procedure
1. Enter the feature location in the user-selectable programming grid.
2. Immediately press and release
3. Select each digit by pressing
the number into the system. To enter a zero, press
To program a PIN code of 1032:
1. Press and release
3. Press and release
a zero.
5. Press and release
three chirps.
6. Press and release
two chirps.
4. Wait for two siren chirps after a five second pause or five seconds after the
last digit has been entered if using less than four digit code number.
5. Turn off the ignition; the siren will chirp three times.
6. The programming mode is now exited.
PIN Code Confirmation Procedure
Begin this procedure within 15 seconds of finishing the programming sequence
or the new code will not be set.
1. Turn on the ignition.
2. Enter the new PIN code.
3. Press and hold
LED turns on: New PIN code is learned and programming is
complete.
LED stays off: New PIN code is not learned and the system reverts to
the old PIN code. Repeat the programming sequence.
Note #6: Accessory Channels
All accessory channels can be programmed to different types of outputs includ-
ing a pulsed output defeated when ignition is on or the system is armed, a pulsed
output regardless of the ignition/armed state, a timed output, a latched output,
or a latched output that resets with ignition on.
© 2004 directed electronics, inc.
of the PlainView 2 Valet switch.
1-9 times, and then press
once and once. You will hear one chirp.
once. You will not hear a chirp after programming
three times, and then press
two times, and then press
for three seconds.
to enter
only.
once. You will hear
once. You will hear
33