Changing The Engine Air Cleaner; Spark Plug - Generac Power Systems 7kW Air-cooled, Automatic Standby Generators Owner's Manual

Maintenance
1 0W -3 0 1 0W -3 0
Synthetic 5W-30 Synt h e ti c 5 W- 30
Any attempt to crank or start the engine
before it has been properly serviced with the
recommended oil may result in an engine
failure.
4.3.3 OIL & OIL FILTER CHANGE PROCEDURE
To change the oil, proceed as follows:
1. Start the engine by moving the AUTO/OFF/MANUAL switch to
MANUAL and run until it is thoroughly warmed up. Then shut
OFF the engine by moving the switch to the OFF position.
2. Immediately after the engine shuts OFF, pull the oil drain hose
(Figure 4.1) free of its zip-tie. Remove the cap from the hose
and drain the oil into a suitable container.
3. After the oil has drained, replace the cap onto the end of the
oil drain hose. Retain the hose in the zip-tie when finished.
Change the engine oil filter as follows:
1. With the oil drained, remove the old oil filter by turning it
counterclockwise.
2. Apply a light coating of clean engine oil to the gasket of the
new filter. See the Specifications section for recommended
filter.
3. Screw the new filter on by hand until its gasket lightly contacts
the oil filter adapter. Then, tighten the filter an additional 3/4 to
one turn (Figure 3.5).
4. Refill with the proper recommended oil (see the Engine Oil
Recommendations section). See the Specifications section
for oil capacities.
5. Start the engine, run for one (1) minute, and check for leaks.
6. Shutdown and recheck oil level, add as needed. DO NOT
OVER FILL.
7. Reset the AUTO/OFF/MANUAL switch to the AUTO position.
8. Dispose of used oil at a proper collection center.
18
S A E 3 0 S A E 30
4.4 CHANGING THE ENGINE AIR
CLEANER
See "The Generator" section for the location of the air cleaner. Use
the following procedures (Figure 4.2):
1. Lift the roof.
2. Turn the two caps counterclockwise to loosen.
3. Remove the cover and air filter.
4. Wipe away dust or debris from inside of the air box and
around edges.
5. Install the new air cleaner into the air box.
6. Install the cover. Turn the two cover caps clockwise to
tighten.
See the Service Schedule section for air cleaner maintenance. See
the Specifications section for air filter replacement part number.
Figure 4.2 — Engine Air Cleaner
Gasket
Cover
4.5

SPARK PLUG

Reset the spark plug gap or replace the spark plug as necessary.
See the Service Schedule section for maintenance requirements.
1. Clean the area around the base of the spark plug to keep dirt
and debris out of the engine.
2. Remove the spark plug and check the condition. Replace
the spark plug if worn or if reuse is questionable. See the
Service Schedule section for recommended inspection. Clean
by scraping or washing using a wire brush and commercial
solvent. Do not blast the spark plug to clean.
3. Check the spark plug gap using a wire feeler gauge. Adjust the
gap to 0.76 mm (0.030 inch) (Figure 4.3).
Caps
Filter