Cleaning The Dryer Interior; Removing Accumulated Lint - Whirlpool WASHER/DRYER User Instructions

Cleaning the Dryer Interior

1. Apply a non-flammable household cleaner to the stained area
of the drum and rub with a soft cloth until stain is removed.
2. Wipe drum thoroughly with a damp cloth.
3. Tumble a load of clean cloths or towels to dry the drum.
NOTE: Garments which contain unstable dyes, such as denim
blue jeans or brightly colored cotton items, may discolor the dryer
interior. These stains are not harmful to your dryer and will not
stain future loads of clothes. Dry unstable dye items inside-out to
prevent dye transfer.

Removing Accumulated Lint

From Inside the Dryer Cabinet
Lint should be removed every 2 years, or more often, depending
on dryer usage. Cleaning should be done by a qualified person.
From Inside the Exhaust Vent
Lint should be removed every 2 years, or more often, depending
on dryer usage.
Moving & Storage
Install and store your washer/dryer where it will not freeze.
Because some water may stay in the hoses, freezing can damage
your washer/dryer. If storing or moving your washer/dryer during
freezing weather, winterize it.
To winterize washer/dryer
1. Shut off both water faucets. Disconnect and drain water inlet
hoses. Put 1 qt (1 L) of R.V.-type antifreeze in the basket.
2. Run washer on a drain and spin setting for about 30 seconds
to mix the antifreeze and water.
3. Unplug washer/dryer or disconnect power.
To use washer/dryer again
1. Flush water pipes and hoses. Reconnect water inlet hoses.
Turn on both water faucets.
2. Plug in washer/dryer or reconnect power.
3. Run the washer through a complete cycle with 1 cup (250 mL)
of detergent to clean out antifreeze.
Non-use or vacation care
Operate your washer/dryer only when you are at home. If you will
be on vacation or not using your washer/dryer for an extended
period of time, you should:
Unplug washer/dryer or disconnect power.
Turn off the water supply to the washer. This helps avoid
accidental flooding (due to a water pressure surge) while you
are away.
To transport the washer/dryer
1. Shut off both water faucets. Disconnect and drain water inlet
hoses. Place the inlet hoses in the basket.
2. If washer/dryer will be moved during freezing weather, put in a
qt (1 L) of R.V.-type antifreeze in the basket. Run washer on a
spin setting for about 30 seconds to mix the antifreeze and
water.
3. Disconnect the drain from the drain system.
4. Unplug washer/dryer or disconnect power.
5. Disconnect the exhaust vent.
6. If your washer/dryer is a gas model, close shutoff valve in gas
supply line, disconnect gas supply line pipe and remove
fittings attached to the washer/dryer pipe.
7. Wash lint screen.
8. Drape the power cord and drain hose over edge and into the
basket.
9. Make sure leveling legs are secure. Use masking tape to
secure the washer lid and dryer door.
Reinstalling your washer/dryer
1. Follow the "Installation Instructions" to locate, level, and
connect the washer/dryer.
2. Run the washer through the Normal cycle with 1 scoop or cap
full of detergent to clean the washer and remove the
antifreeze, if used.
7