Check The Print Quality - Brother MFC-J6510DW Quick Setup Manual

CAUTION
If ink gets in your eyes, wash it out with water at
once and call a doctor if you are concerned.
IMPORTANT
• DO NOT take out ink cartridges if you do not
need to replace them. If you do so, it may
reduce the ink quantity and the machine will
not know the quantity of ink left in the
cartridge.
• DO NOT repeatedly insert and remove the
cartridges. If you do so, ink may seep out of
the cartridge.
• If you mix the colours by installing an ink
cartridge in the wrong position, clean the
print head several times after correcting the
cartridge installation. (See Cleaning the
print head in Appendix A of the Basic User's
Guide.)
• Once you open an ink cartridge, install it in
the machine and use it up within six months
of installation. Use unopened ink cartridges
by the expiration date written on the
cartridge package.
• DO NOT dismantle or tamper with the ink
cartridge, this can cause the ink to leak out
of the cartridge.
• Brother multifunction machines are
designed to work with ink of a particular
specification and will work to a level of
optimum performance when used with
genuine Brother branded ink cartridges.
Brother cannot guarantee this optimum
performance if ink or ink cartridges of other
specifications are used. Brother does not
therefore recommend the use of cartridges
other than genuine Brother branded
cartridges with this machine or the refilling
of empty cartridges with ink from other
sources. If damage is caused to the print
head or other parts of this machine as a
result of using incompatible products with
this machine, any repairs required as a
result may not be covered by the warranty.
6

Check the print quality

Note
Make sure you put paper in the paper tray (For
MFC-J6710DW, tray #1, the upper tray) for the
initial setup.
a
When the preparation process has finished, the
LCD shows Set Paper and Press Start.
Press Colour Start.
b
Check the quality of the four colour blocks on
the sheet. (black/yellow/cyan/magenta)
c
If all lines are clear and visible, press 1 (Yes)
on the dial pad to finish the quality check and
go to step 7.
If you can see missing short lines, press 2 (No)
on the dial pad and follow the steps on the
LCD.
7
Set the paper settings
For your machine to produce the best print quality and
feed the correct paper size, the paper type and size
must be set to match the paper in the tray.
For details on the types and sizes of paper supported,
see Paper Size and Type in chapter 2 of the Basic
User's Guide.
Note
(For MFC-J6710DW)
You can change the default tray the machine will
use for printing copies or received faxes. (See
Tray use in Copy mode or Tray use in Fax mode
in chapter 2 of the Basic User's Guide.)
a
When the LCD shows to set the paper size and
paper type, press Tray Setting or Paper
Setting (depending on your model).
OK
Poor
7