Operation - Mitsubishi Electric PCA-RP·GA Operation Manual

2. Operation

1
2
3
FAN AUTO STOP
MODE VANE AUTO START
CHECK LOUVER h
TEST RUN min
SET RESET CLOCK
1
B
B
1
2
2
A
A
1
1
4
6
5
˚C
˚C
TEMP.
ON/OFF
FILTER
CHECK TEST
TIMER SET
˚C
˚C
TEMP.
ON/OFF
FILTER
CHECK TEST
TIMER SET
˚C
˚C
TEMP.
ON/OFF
FILTER
CHECK TEST
TIMER SET
Replacing the Batteries and how to set the current time
If no signal is transmitted and the indoor unit's lamp does not light up even
if the remote controller is operated, the batteries may have run out, so
replace them with new ones as described below.
1 Remove the front lid.
2 Replace the batteries with alkali batteries (size AAA). Make sure that
the batteries are installed in the correct direction. (Insert the minus
pole of the batteries first.)
3 Reattach the front lid.
4 Press the RESET button using a thin stick.
h
5 Press the
and
6 Press the CLOCK button using a thin stick and close the front lid.
If you are not going to use the unit for a long period of time, remove the
batteries to prevent damage which may occur due to leakage of electro-
lyte.
Check if your remote controller is the wired type or the wireless type before
referring to the illustration and text for operation procedures.
2.1. Switching the unit on/off
• The power supply should not be turned off while the air conditioner is in
use. This can cause the unit to break down.
A
1 Press the ON/OFF button.
1
AThe ON indicator should light up.
• Even if you press the ON/OFF button immediately after shutting down
the operation in progress, the air conditioner will not start for about three
minutes. This is to prevent the internal components from being dam-
aged.
• If the operation stops due to a power failure, the unit will not automati-
cally restart until the power has been restored. Press the ON/OFF but-
ton to restart.
2.2. Mode select
1 If the unit is off, press the ON/OFF button to turn it on.
AThe ON indicator should light up.
2 Press the operation mode (
eration mode.
A B
1
s Cooling mode
Fan mode
Heating mode
Drying mode
Automatic (cooling/heating) mode
Note:
The heating display and the automatic display does not appear in models that
operate exclusively as cooling only air-conditioner.
2.3. Selecting a temperature
s s s s s To decrease the room temperature:
1 Press button to set the desired temperature.
AThe selected temperature is displayed.
• Each time you press the button, the temperature value decreases by 1
°C.
s s s s s To increase the room temperature:
1 Press button to set the desired temperature.
AThe selected temperature is displayed.
• Each time you press the button, the temperature value increases by 1
°C.
• Available temperature ranges are as follows:
Cooling & Drying:
Heating:
Automatic:
Circulation:
• The display flashes either 8 °C - 39 °C to inform you if the room tem-
perature is lower or higher than the displayed temperature.
min
button to set the current time.
) button and select the op-
TEMP.
19 - 30 °C
17 - 28 °C
19 - 28 °C
— (Not available)
3