Care And Cleaning - Mitsubishi Electric PCA-RP·GA Operation Manual

2. Operation

3. Care and cleaning

I PKA-RP·GAL
I PKA-RP·FAL
I PCA-RP·GA
C
A
13
2
B
A
A
B
D
For wireless remote controller
AUTO STOP AUTO START
1Press the
or button (TIMER SET).
• Time can be set while the following symbol is blinking.
OFF timer : A
is blinking.
ON timer : A
is blinking.
h min
2 Use the
and buttons to set the desired time.
3 Canceling the timer.
To cancel the OFF timer, press the
To cancel the ON timer, press the
• It is possible to combine both OFF and ON timers.
• Pressing the ON/OFF button of the remote controller during timer
mode to stop the unit will cancel the timers.
• If the current time has not been set, the timer operation cannot be used.
3.1. Cleaning the filters and the indoor unit
Cleaning the filters
• Clean the filters using a vacuum cleaner. If you do not have a vacuum
cleaner, tap the filters against a solid object to knock off dirt and dust.
• If the filters are especially dirty, wash them in lukewarm water. Take care
to rinse off any detergent thoroughly and allow the filters to dry com-
pletely before putting them back into the unit.
Caution:
• Do not dry the filters in direct sunlight or by using a heat source,
such as an electric heater: this may warp them.
• Do not wash the filters in hot water (above 50°C), as this may warp
them.
• Make sure that the air filters are always installed. Operating the
unit without air filters can cause malfunction.
Caution:
• Before you start cleaning, stop operation and turn OFF the power
supply.
• Indoor units are equipped with filters to remove the dust of sucked-in
air. Clean the filters using the methods shown in the following sketches.
Filter removal
Caution:
• In removing the filter, precautions must be taken to protect your
eyes from dust. Also, if you have to climb up on a stool to do the
job, be careful not to fall.
• When the filter is removed, do not touch the metallic parts inside
the indoor unit, otherwise injury may result.
I PKA-RP·GAL
1 Pull both the bottom corners of the intake grille to open the grille,
then lift the filter.
I PKA-RP·FAL
1 Hold the filter lug (located at the bottom of the intake grille) and pull it
out downward.
AFilter
BLug
• To reinstall the filters, push the filter lug upward.
I PCA-RP·GA
1 Open the intake grille.
2 Hold the knob on the filter then pull the filter up in the direction of an
arrow. To replace the filter after cleaning, be sure to insert the filter
far enough until it fits into the stopper.
AFilter BIntake Grille
AUTO STOP
button.
AUTO START
button.
CKnob DStopper
5