Reverse Light; Remote Start Activated (-) Output; Factory Alarm Disarm (-) Output - Avital AVISTART 2501 Installation Manual

Remote engine starter system

Hide thumbs Also See for AVISTART 2501:

Table of Contents

Glow Plug Light Monitoring

The glow plug light (+) input wire will monitor the glow plug light in the

dashboard. When a remote start is attempted, the ignition will turn on and

when the glow plug light turns "OFF" the engine will start

1 . Locate the glow plug light wire that will show (+) 12 volts while the

ignition key is on and the glow plug light wire is illuminated.

2 . Connect the AviStart ORANGE/BLACK wire to the vehicle glow plug

might wire.

NOTE: Do not use both "pre-ignition" and "glow plug light monitoring" at

the same time (use one or the other).

Reverse Light

CAUTION : Some vehicles allow you to remove the gear shift

selector from "Park" even while the ignition key is not on. As a safety

feature, the system will monitor the reverse wire. If the vehicle is

removed from "Park" while in the remote start mode, the system will

shut down immediately.

1 . Set the parking brake.

2 . Turn the ignition key to the "ON" position and adjust the gear shift selector

to "Reverse."

3 . Use a voltmeter to find the wire that will show +12 volts in "Reverse" and

0 volts in "Park."

4. Connect the YELLOW/BLACK wire to the vehicle's reverse light wire.

The GRAY/BLACK wire will provide a continual ground output for as long as

the vehicle is in the remote start mode. This output can be used for additional

ignition, starter or heater/AC relays, VATS, Passlok and Passkey bypass.

The GRAY/WHITE wire will provide a 0.75 second ground output when the

START button is pressed.

1 . Arm the vehicle factory alarm system.

2. Use a volt/ohmmeter to locate the one wire that will show ground only

when the driver door key cylinder is held in the unlock position.

AviStart 2501 Installation Manual - Rev. B 100199

Con tin ued on next page.

Table of Contents