Table of Contents
Advertisement
Reverse Light
I
CAUTION : Some vehicles allow you to remove the gear shift
selector from "Park" even while the ignition key is not on. As a safety
feature, the system will monitor the reverse wire. If the vehicle is
removed from "Park" while in the remote start mode, the system will
shut down immediately.
1 . Set the parking brake.
2 . Turn the ignition key to the "ON" position and adjust the gear shift selector
to "Reverse."
3 . Use a voltmeter to find the wire that will show +12 volts in "Reverse" and
0 volts in "Park."
4. Connect the YELLOW/BLACK wire to the vehicle's reverse light wire.
Remote Start Activated (-) Output
The GRAY/BLACK wire will provide a continual ground output for as long as
the vehicle is in the remote start mode. This output can be used for additional
ignition, starter or heater/AC relays, VATS, Passlok and Passkey bypass.
Factory Alarm Disarm (-) Output
The GRAY/WHITE wire will provide a 0.75 second ground output when the
START button is pressed.
1 . Arm the vehicle factory alarm system.
2. Use a volt/ohmmeter to locate the one wire that will show ground only
when the driver door key cylinder is held in the unlock position.
NOTE: Most factory alarm/disarm wires will show 8-12 volts while
armed. A few vehicle disarm wires will rest at a neutral state while
armed. Regardless of type, both types will change to ground when the
key cylinder is turned to unlock.
3 . Connect the GRAY/WHITE wire to the factory alarm disarm wire.
Factory Alarm Rearm
There are two types of factory alarm systems that the AviStart can rearm.
6
AviStart 3001 Installation Manual, Revision B 100199
Con tin ued on next page.
Advertisement
Table of Contents
