Table of Contents
Advertisement
Ignition #1 Ignition #2
The AviStart module has two onboard 30-amp relays. Most vehicles have only
one ignition wire necessary to start the vehicle. Some vehicles have two
ignition wires. Make all wire connections at the ignition switch wire harness.
1 . Use a voltmeter to locate the wire(s) that show +12 volts while the ignition
key is in the "ON," "CRANK" and "RUN" positions and 0 volts when the
ignition key is in the "OFF" position.
2 . Connect the 14 ga PINK wire(s) to the vehicle ignition wire(s).
Heater/AC
The AviStart module has one onboard 30-amp relay. Most vehicles have only
one heater/AC wire. If additional heater/AC wires are required to activate the
vehicle's heater/AC system, an additional 30-amp relay must be added. Do
not use the GRAY wire to power more than one heater/AC wire.
1. Use a voltmeter to find the wire(s) that show +12 volts when the ignition
key is in the "ON" position, 0 volts while the starter is cranking and +12
volts while running.
2 . Cut this wire in half. Start the vehicle and turn the blower switch on. The
blower should not turn on.
3. Connect the GRAY wire to the heater/AC wire.
Starter
I
WARNING: Review the "Safety Bulletin" and diagrams on pages
10-12 prior to installing the starter system.
1 . Use a voltmeter to find the wire that shows +12 volts while the ignition
key is in the "CRANK" position only and 0 volts while the key is in the
"OFF," "ON" and "RUN" positions.
2. Connect the VIOLET wire to the starter wire.
AviStart 2501 Installation Manual - Rev. B 100199
9
Advertisement
Table of Contents
