Troubleshooting - Horizon Fitness Eclipse Installation And Operation Manual

Troubleshooting

Symptom
Machine Won't
Run
Cannot start the
dehumidifier
Loud Noise
Trouble code:E1
Trouble code
Pump Alarm-Error Code E2/E4
If a pump alarm is provided on display:
1. Reset unit by disconnecting power cord and then reconnecting. NOTE:
Unit will not function until error code has been cleared.
2. Manually check to see if pump is operational. Press manual drain
button and see if pump energizes and de-energizes prop and if any water
is purged from system. If you haven't cleaned the system recently,
check discharge line for obstruction and clean balance of pump system
per instruction above.
3. Replace hoses and or pump if maintenance alone is not sufficient.
Cause
Power Cord Connection
Room temperature Over
105 degree F or Below 33
Degree F
Air Filter Clogged
Air inlet or outlet jammed
Machine Not Level
Filter mesh jammed
E1 = Humidity Sensor
Issues.
Flashing Red =
Temperature Sensor
Issues
15
Solution
Insure Plug Fully Inserted in
Outlet
Units Outside Operating
Temperature Range，Manual
restart of machine after room
returns to design conditions
Clean the filter mesh according
to instructions in manual
Clear the blockage from air
inlet or air outlet
Move to flat and firm ground
Clean the filter mesh according
to instructions in manual
Check to insure wire is
connected at both ends. If all
looks good, sensor may be
faulty.
Check to insure wire is
connected at both ends. If all
looks good, sensor may be
faulty.