Log Placement; Placement Of Glowing Embers (Rock Wool) - Empire Comfort Systems VFH-33M-1 Installation Instructions And Owner's Manual

1. Install the rear log (#3) behind the pilot assembly directly on
the pins on each side of the rear log shield.
2. The middle log (#2) will go directly on the two pins on the
flat portion of the burner.
3. Install the front log (#1) in front of the grate. The log is located
into a notch area in the front grate area.
4. Check all items for any shipping damage. If damaged, promptly
inform dealer where you bought heater.
Refer to Figure 14 for the following warning.
Warning: Failure to positon the parts in accordance with this
diagram or failure to use only parts specifically approved with
this heater may result in property damage or personal injury.
Operation
This heater requires no outside venting. This heater is designed for
vent-free operation with flue damper closed. State and local codes
in some areas prohibit the use of vent-free heaters.

PLACEMENT OF GLOWING EMBERS (ROCK WOOL)

Provided with the log set is a small bag of glowing embers (rock
wool) to be placed between logs on the flat metal surface of the
burner.
Placement of the embers (rock wool) is very individual and light
coverage of the areas indicated will provide your best effects. We
recommend separation of the rock wool by hand and make your
coverage as light and fluffy as possible.
Place just enough embers (rock wool) on the burner to obtain the
glow and a gold yellow flame.
Do not place rock wool over large ports in rear portion of burner.
A thin layer of rock wool should be placed under open space be-
tween the right and left middle logs.
Rock wool should not be placed in the area of the pilot assembly.
Page 14

LOG PLACEMENT

Figure 14
TOP VIEW OF LOG SET
REAR LOG
EMBER PLACEMENT
Placement of glowing embers (rock wool)
Figure 15
VFH-33