NAD C 446 Owner's Manual page 8

IDENTIFICATION OF CONTROLS
REAR PANEL
9 +12V TRIGGER IN
This input allows the C 446 to be switched remotely to standby mode
and ON by ancillary equipment, such as an amplifier, preamplifier,
receiver, etc. The controlling device must be equipped with a +12V
trigger output to use this feature. Connect this +12V Trigger input to
the remote device's corresponding +12V DC output jack using a mono
cable with 3.5mm male plug.
10 IR IN
• This input is connected to the output of an IR (infrared) repeater
(Xantech or similar) or the IR output of another component to allow
control of the C 446 from a remote location.
11 POWER
• Supply the AC mains power to the C 446.
• When the POWER switch is set to ON position, the C 446 goes to
standby mode as shown by the amber status condition of the
Standby LED. Press the front panel Standby button or TNR 2 remote
control's [ON] button to switch ON the C 446 from standby mode.
• If you intend not to use the C 446 for long periods of time (such as
when on vacation), switch off the POWER switch.
• With POWER switched off, neither the front panel Standby button
nor TNR 2 remote control's [ON] button can activate the C 446.
12 AC MAINS INPUT
The C 446 comes supplied with a separate detachable mains power
cord. Before connecting the plug to the mains power source, ensure
that it is firmly connected to the C 446's AC Mains input socket first.
• Connect only to the prescribed AC outlet, i.e., 120V 60 Hz (120V
version model only) or 230V 50 Hz (230V version model only).
• Always disconnect the mains power plug from the mains power
source first, before disconnecting the cable from the C 446's AC
Mains input socket.
8