Care And Cleaning; Control Panel; Lift-Off Oven Door; Packaging Tape - GE JCKP30–27 ? Owner's Manual

Care and cleaning of the oven.
WARNING:
of the oven.
Slot
Hinge lock
Pull hinge locks down to unlock
Removal position
22
Be sure electrical power is off and all surfaces are cool before cleaning any part
How to Remove Protective Shipping Film and Packaging Tape
Carefully grasp a corner of the protective
shipping film with your fingers and slowly
peel it from the appliance surface. Do not use
any sharp items to remove the film. Remove
all of the film before using the appliance for
the first time.
To assure no damage is done to the finish
of the product, the safest way to remove the

Control Panel

It's a good idea to wipe the control
panel after each use. Clean with mild soap
and water or vinegar and water, rinse with
clean water and polish dry with a soft cloth.
When cleaning, the control panel should be
at room temperature and not in direct
sunlight.

Lift-Off Oven Door

The door is very heavy. Be careful when
removing and lifting the door.
Do not lift the door by the handle.
To remove the door:
Fully open the door.
Pull the hinge locks down toward
the door frame, to the unlocked
position. A tool, such as a small
flat-blade screwdriver, may be required.
Firmly grasp both sides of the door at
the top.
Close door to the door removal position
(see illustration).
Lift door up and out until the hinge
arm is clear of the slot.
To replace the door:
Firmly grasp both sides of the door at
the top.
adhesive from packaging tape on new
appliances is an application of a household
liquid dishwashing detergent. Apply with a
soft cloth and allow to soak.
NOTE: The adhesive must be removed from all parts.
It cannot be removed if it is baked on.
Do not use abrasive cleansers, strong liquid
cleansers, plastic scouring pads or oven
cleaners on the control panel—they will
damage the finish. A 50/50 solution of
vinegar and hot water works well.
With the Bottom
edge
door at the
of slot
same angle as
the removal
position, seat the
indentation of
the hinge arm
into the bottom edge
of the hinge slot. The
notch in the hinge arm must be fully
seated into the bottom of the slot.
Fully open the door. If the door will not
fully open, the indentation is not seated
correctly in the bottom edge of the slot.
Push the hinge locks up against the
front frame of the oven cavity, to the
locked position.
Hinge
arm
Hinge lock
Push hinge locks up to lock
Close the oven door.
Hinge arm
Indentation