Clock And Timer - GE JCKP30–27 ? Owner's Manual

Using the clock and timer.
Make sure the clock is set to the
correct time of day.
The timer is a minute timer only.
The timer does not control oven
operations. The maximum setting on
the timer is 9 hours and 59 minutes.
To Set the Clock
The clock must be set to the correct time
of day for the automatic oven timing
functions to work properly. The time of
day cannot be changed during a timed
baking or self-cleaning cycle.
To Set the Timer
Press the Timer pad.
On models with number pads, press
them until the amount of time you
want shows in the display. For
example, to set 2 hours and 45
minutes, press 2, 4 and 5 in that
order.
On models with Hour and Min +
and – pads, press them until the
amount of time you want shows in
the display. The maximum time you
can enter in minutes is 59. Cooking
times more than 59 minutes should
be changed to hours and minutes.
For example, enter 90 minutes as
1 hour, 30 minutes.
If you make a mistake, press Timer
and begin again.
To Reset the Timer
If the display is still showing the time
remaining, you may change it by pressing
the Timer pad, then press the number
pads (on some models) or the Hour and
Min + or – pads (on some models) until
the time you want appears in the display.
To Cancel the Timer
Press the Timer pad twice.
www.GEAppliances.ca
Press the Clock pad.
On models with number pads, press
them in order to set the correct time
of day.
On models with Hour and Min +
and – pads, press them to set the
correct time of day.
Press the Start pad.
Press the Start pad.
After pressing the Start pad, SET disappears;
this tells you the time is counting down, although
the display does not change until one minute
has passed. Seconds will not be shown in the
display until the last minute is counting down.
When the timer reaches :00, the
control will beep 3 times followed
by one beep every 6 seconds until
the Timer pad is pressed.
The 6-second tone can be canceled by following
the steps in the Special features of your oven
control section under Tones at the End of a
Timed Cycle.
If the remaining time is not in the display
(clock, delay start or cooking time are in
the display), recall the remaining time by
pressing the Timer pad and then pressing
the number pads (on some models) or
the Hour and Min + or – pads (on some
models) to enter the new time you want.
9