Hiniker 7802 Operator's Manual page 19

Use plastic tie straps to band headlamp
cables above and below the brackets at the
locations shown to provide clearance for
the power unit cover later.
Refer to sections titled "System Check-Out"
and "Headlamp Aiming Procedure" in this
manual for aiming instructions.
7. Identify the plow power cable assembly
and plow wiring harness in the parts box. A
ground wire harness for the solenoids is in
the power unit box.
The power cable for the snowplow has two
cables with ring terminals on one end and
a two pin connector on the other and mea-
sures about 38" long.
The plow wiring harness has a 16-pin con-
nector on one end and the other end has
connectors labeled "DRIVER SIDE" and
"PSNGR SIDE" for the headlamps and
three loose wires with spade terminals.
The ground wire for the solenoids has one
7 inch long wire and two wires 11 inches
long. There is a 1/4 inch ring terminal on the
common end and three spade receptacles
on the remaining ends.
NOTE: To prevent corrosion apply a light coat
of dielectric grease to all electrical connections
including ring and spade terminals.
DWG NO. 6312B
Refer to drawing 6502. Attach the ring ter-
minal of the solid red (or red-striped) wire
of the power cable assembly to the terminal
on the power unit at location 1.
Fasten the ring terminal of the solid black
wire of the power cable assembly and the
ring terminal of the solenoid ground wire
harness to the terminal on the motor at lo-
cation 2.
Connect the three black wires of the ground
harness to solenoids S1, S2 and S3.
Connect the gray wire from the wiring har-
ness to solenoid S1. S1 extends the right
side of the plow to plow left.
Connect the tan wire from the wiring har-
ness to solenoid S2. S2 extends the left
side of the plow to plow right.
Connect the blue wire from the wiring har-
ness to solenoid S3. S3 lowers the plow.
Connect the RH headlamp to the wiring har-
ness end labeled "PSNGR SIDE" and the
LH headlamp to the end labeled "DRIVER
SIDE".
Ensure connections are fully mated for
proper sealing. There should be no gaps
between connector halves. Secure these
cables to the frame with plastic ties.
Plow Assembly 17
DWG NO. 6502