KitchenAid W10440551A Installation Instructions Manual page 12

Electrical Connection Options
If your home has: And you will be
connecting to:
4-wire receptacle A UL listed,
(NEMA type 14-50R) 250-volt
minimum,
40-amp, range
power supply
cord
4-wire direct A fused
disconnect or
circuit breaker
box
5"
(12.7 cm)
3-wire receptacle A UL listed,
(NEMA type 10-50R) 250-volt
minimum,
40-amp, range
power supply
cord
3-wire direct A fused
disconnect or
1"
circuit breaker
(2.5 cm)
box
3"
(7.6 cm)
4-wire connection: Power Supply Cord
Use this method for:
New branch-circuit installations (1996 NEC)
Mobile homes
Recreational vehicles
In an area where local codes prohibit grounding through the
neutral.
1. Remove the ground-link screw from the range frame. Save
the ground link screw and cup washer. Bend the ground-link
away from the range so that it does not contact the range.
B
A
A. Ground-link screw
B. Cup washer
C. Ground-link bent away from range
2. Connect the green ground wire from the power supply cord to
the range using the ground-link screw. The ground wire must
be attached first and must not contact any other terminal.
12
3. Use a ¼" nut driver and remove the hex washer head screws
Go to Section:
4. Connect the neutral (center) wire to the center terminal
4-wire connection:
Power supply cord
4-wire connection:
Direct wire
3-wire connection:
Power supply cord
5. Connect the other 2 wires (lines 1 and 2) to the outer
3-wire connection:
Direct wire
6. Securely tighten screws.
7. Tighten strain relief screws.
8. Replace terminal block cover with screw.
Use this method only if local codes permit connecting cabinet-
ground conductor to neutral wire of power supply cord.
1. Use a ¼" nut driver and remove the hex washer head screws
2. Connect the neutral (center) wire to the center terminal
C
3. Connect the other 2 wires (lines 1 and 2) to the outer terminal
4. Tighten strain relief screws.
5. Replace terminal block cover with screw.
from the terminal blocks.
connector using one of the hex washer head screws.
Securely tighten screw.
D
C
B
A
A. Line 1
B. Green ground wire
C. Ground-link screw
D. Hex washer head
screw
E. Silver-colored terminal
block screw
aluminum terminal blocks.
3-wire connection: Power Supply Cord
from the aluminum terminal blocks.
connector using one of the hex washer head screws.
Securely tighten screw.
C
B
A
A. Line 1
B. Ground-link
C. Hex washer head screw
D. Silver-colored terminal
block screw
screws on the terminal block.
E
F
G
H
I
F. Ground-link
G. Neutral (center) wire
H. Line 2
I. UL listed strain relief
and 40-amp range
power supply cord
D
E
F
G
E. Neutral (center) wire
F. Line 2
G. UL listed strain relief
and 40-amp range power
supply cord