Gtech CM01 Safety And Instruction Manual page 7

Cordless cylinder mower
Table of Contents

Advertisement

Battery Charging & Recharging
Charge the battery for 16 hours before first use.
Warning : if the battery is damaged in any way do not attempt to charge it, and
replace it immiediatly
The battery can be charged in or out of the product.
To charge the battery in the product, remove the
isolator key and plug the charger connector onto
the battery socket.
To charge the battery out of the product, first remove the isolator key, raise the handle and
lift the battery out of the product. Place the battery on a dry, flat surface. Plug the charger
connector onto the battery socket.
Plug the charger adaptor into a suitable electrical socket and switch on.
Once the battery is fully charged remove the charger connector from the battery and
unplug the charger adaptor from the mains socket.
Do not pull the charger by the cord.
From flat the battery requires 16 hours to fully charge.
Note : there is no indicator on the charger to show when the battery is charging or
fully charged. Charge the battery for 16 hours after use to ensure a full charge.
The battery will not be damaged if charged for longer than 16 hours, but do not
charge for longer than 48 hours.
IMPORTANT - to keep the battery in good condition charge the battery after each
use. Never store the battery flat.
If storing the battery for long periods then charge the battery every 3 months.
Warning : only use the charger provided with the product. Using any other
charger may damage the product and the battery.
Only use a replacement battery as supplied by manufacturer.
Replacement batteries can be purchased from Grey Technology.
Tel : 0870 7944001
www.greytechnology.co.uk
Gtech helpline : 0870 7944001
email: support@greytechnology.co.uk

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CM01 and is the answer not in the manual?

Table of Contents

Save PDF