Yamaha RX-V1600 Owner's Manual page 37

AUTO SETUP
For best results, make sure the room is as quiet as possible
during the AUTO SETUP procedure (YPAO). If there is
too much ambient noise, the results may not be
satisfactory.
AMP
.,
SET MENU
SOURCE
t
MEN
(0)
SRCHMOD
TV
<0
2
Press
/11
\j to select AUTO SETUP and then
press ENTER once to enter the main menu.
1
Set AMP/SOURCEfTV to AMP and then press
SET MENU to enter the SET MENU.
CROSSOVER
HIGH CUT
-0-
MI~ ~A:/
'\
Subwoofer
VOLUME
<0-
MIN MAX
,I,
~'i>-:'
• You can run AUTO SETUP using the system menu that appears
in the OSD or in the front panel display. This manual uses the
OSD illustrations to explain the AUTO SETUP procedure.
• If an error occurs during the AUTO SETUP procedure and an
error message appears in the front panel display, see pages 115
and 116 for a complete list of error messages and proper
remedies.
• If your subwoofer can adjust the output volume and the
crossover frequency, set the volume to about half way (or
slightly less) and set the crossover frequency to the maximum.
(U.S.A. model)
1
2-9
C... ].····CT]:UP.····[)OI.'Jn
[a·HEP] : Erlter'
PRESET/CH
3
Press \j to select SETUP and then press
<J
1
[>
to select:
AUTO
To automatically perform the entire AUTO SETUP
procedure.
RELOAD
To restore the last AUTO SETUP setting.
RELOAD is available only when you have previously run
the AUTO SETUP procedure.
33
AUTO SETUP
For best results, make sure the room is as quiet as possible
during the AUTO SETUP procedure (YPAO). If there is
too much ambient noise, the results may not be
satisfactory.
AMP
.,
SET MENU
SOURCE
t
MEN
(0)
SRCHMOD
TV
<0
2
Press
/11
\j to select AUTO SETUP and then
press ENTER once to enter the main menu.
1
Set AMP/SOURCEfTV to AMP and then press
SET MENU to enter the SET MENU.
CROSSOVER
HIGH CUT
-0-
MI~ ~A:/
'\
Subwoofer
VOLUME
<0-
MIN MAX
,I,
~'i>-:'
• You can run AUTO SETUP using the system menu that appears
in the OSD or in the front panel display. This manual uses the
OSD illustrations to explain the AUTO SETUP procedure.
• If an error occurs during the AUTO SETUP procedure and an
error message appears in the front panel display, see pages 115
and 116 for a complete list of error messages and proper
remedies.
• If your subwoofer can adjust the output volume and the
crossover frequency, set the volume to about half way (or
slightly less) and set the crossover frequency to the maximum.
(U.S.A. model)
1
2-9
C... ].····CT]:UP.····[)OI.'Jn
[a·HEP] : Erlter'
PRESET/CH
3
Press \j to select SETUP and then press
<J
1
[>
to select:
AUTO
To automatically perform the entire AUTO SETUP
procedure.
RELOAD
To restore the last AUTO SETUP setting.
RELOAD is available only when you have previously run
the AUTO SETUP procedure.
33