Yamaha RX-V1600 Owner's Manual page 120

TROUBLESHOOTING
After AUTO SETUP
Warning message Cause Remedy
See
page
Speaker polarity is not correct. This
W-1:0UT OF PHASE
message may appear depending on the
Check the speaker connections for proper polarity
15
speakers even when the speakers are
(+
or -).
connected correctly.
W-2:0VER 24m (80ft)
The distance between the speaker and the
Bring the speaker closer to the listening position. -
listening position is over 24 m (80 ft).
Readjust the speaker installation so that all speakers
-
are set in locations with similar conditions.
The difference of volume level among
Check the speaker connections. 15
W-3:LEVEL ERROR
speakers is excessive. (No level correction
is made.)
Use speakers of similar quality. -
Adjust the output volume of the subwoofer.
33
• If the ERROR or WARNING screens appears, check the cause of the problem, then perform the AUTO SETUP procedure again.
• If warning W- Lappears, corrections are made, but they may not be optimal.
• If warning W-2 or W-3 appears, no corrections are made.
• If error E-I 0 occurs repeatedLy, please contact a qualified YAMAHA service center.
• HDMI
Error message Cause Remedy
See
page
DEVICE OVER
More than 5 HOMI components including Reduce the number of the connected HOMI
this unit are connected. components.
-
HDCP ERROR
HOCP testing failed.
Check that the connected HDMI components support
-
the HDCP copy protection standards.
116
TROUBLESHOOTING
After AUTO SETUP
Warning message Cause Remedy
See
page
Speaker polarity is not correct. This
W-1:0UT OF PHASE
message may appear depending on the
Check the speaker connections for proper polarity
15
speakers even when the speakers are
(+
or -).
connected correctly.
W-2:0VER 24m (80ft)
The distance between the speaker and the
Bring the speaker closer to the listening position. -
listening position is over 24 m (80 ft).
Readjust the speaker installation so that all speakers
-
are set in locations with similar conditions.
The difference of volume level among
Check the speaker connections. 15
W-3:LEVEL ERROR
speakers is excessive. (No level correction
is made.)
Use speakers of similar quality. -
Adjust the output volume of the subwoofer.
33
• If the ERROR or WARNING screens appears, check the cause of the problem, then perform the AUTO SETUP procedure again.
• If warning W- Lappears, corrections are made, but they may not be optimal.
• If warning W-2 or W-3 appears, no corrections are made.
• If error E-I 0 occurs repeatedLy, please contact a qualified YAMAHA service center.
• HDMI
Error message Cause Remedy
See
page
DEVICE OVER
More than 5 HOMI components including Reduce the number of the connected HOMI
this unit are connected. components.
-
HDCP ERROR
HOCP testing failed.
Check that the connected HDMI components support
-
the HDCP copy protection standards.
116