Call Barring - EnGenius SN933 User Manual

Re : "00" means all handsets
iv. During phonebook transferring, LCD shows "Sending" and 2-digit
countdown on the LCD will indicate the remaining phonebook
numbers which are still pending to be sent.
c. For the phone that is to receive the phonebook, press
mode.
i. When entering the receiving mode, the LCD will show "Ready".
ii. To start to receiving the phonebook, the LCD will show "Get
phonebook from Ext. # : xx" (the handset ID that will be doing the
sending).
iii. A beep will be emitted when receiving each phonebook entry.
iv. While receiving phone book entries, a 2-digit countdown on the LCD
will indicate the number of phonebook numbers remaining.
Re: Note: The phonebook transfer is via a wireless interface so there can be
times where some entries are not transferred due to interference. It
is recommended to have handsets in very close range during
transfers.

Call Barring

1. Block the users from dialing long distance or international calls. Call barring can
also be used to block incoming calls from an outside line or other registered
handset.
Note: Entering a password is required (default password is 0000).
2. Press MENU-4-3 to enter Call Barring. Enter the password
of the handset, followed by OK (Left) soft key
Block Outgoing Call
1. Press SELECT left soft key to select "Outgoing" and confirm
your selection.
2. Use
or scrolling key to switch between On and
Off of this setting. Press SELECT left soft key to confirm
your selection.
Re： ： ： ： The default setting of Call Barring is "Off".
2 to enter receiving
~43~
3. To enter a Call Barring code
a. Once the Call Barring feature is turned on, you can key
in the "Call Barring" code.
Press ADD (Left) soft key then start entering the Call
Barring code after the number is entered, then press
the SAVE (Left) soft key to save.
(1) Up to 5 digits can be entered in as a Barring code.
For example, if you want to block all call dialing to a
1900 service, you can enter 1900 as the Call Barring
code.
(2) If the base station is connected behind a PBX
system, be sure to include the outside dial tone
digit as well (example, 9 to dial out).
b. Press OPTION right soft key to delete or edit Call
Barring codes.
c. Up to 5 sets of Call Barring codes can be programmed.
d. If you want to block all outgoing calls, enter ＊＊＊＊
＊ keys followed by, press
SAVE
Doing so will cause all outgoing calls to be restricted.
Block Incoming Calls and blocking intercom or broadcasts
from handsets.
1. Press SELECT left soft key to confirm your selection for
"Incoming".
Use or scrolling key to select blocking item.
a. Press
SELECT left soft key to confirm your selection to
block broadcasts.
Press CHANGE left soft key to switch between On and
Off of this setting.
Re: "On" means to be able to receive broadcast from
other handsets or base station. "Off" means to restrict
the broadcast from other handsets or base station. The
default setting is "On".
(Left) soft key to save.
~44~