System Features Learn Routine - Viper 600 ESP Installation Manual

system features learn routine

The System Features Learn Routine™ dictates how the unit operates. Due to the number of steps, they have been
broken up into two menus. It is possible to access and change any of the feature settings using the
Valet®/Program switch. However, this process can be greatly simplified by using the optional DEI Bitwriter or
Personal Computer Interface, P/N 996T. Any of the settings can be changed and then assigned to a particular
transmitter, up to four, a feature called Owner Recognition. Each time that particular transmitter is used to disarm
the system, the assigned feature settings will be recalled. Owner Recognition is only possible when programming
the unit via the 996T or the 998T DEI Bitwriter.
Using the optional DEI Bitwriter or PC Interface, the learn routine may be locked. Make sure the learn routine is
unlocked before programming features. If the siren generates one long chirp when attempting to program the
unit, the learn routine is locked and must be unlocked using the DEI Bitwriter or PC before proceeding.
1. Open a door: The H1/5 GREEN wire or the H1/7 VIOLET wire must be connected.
2. Ignition: Turn the ignition on, then back off: The H1/9 YELLOW wire must be connected.
3. Select a menu: Press and HOLD the Valet®/Program button: The Valet®/Program button
must be plugged into the blue port. After three seconds the siren will chirp once indicat-
ing entry to the Basic Features Menu #1. If this is the menu you wish to access, release
the button and go on to step 4. If the button is not released, you will jump to the
Advanced Features Menu #2 and the siren will chirp twice. Once you have selected the
desired menu, release the Valet®/Program button and then go to step four.
4. Select a feature: Press and release the Valet®/Program button the number of times corre-
sponding to the step you wish to change. For example, to access the third feature, press
and release three times. Then press the button once more and HOLD it. The siren will chirp
the number of times equal to the step you have accessed.
5. Program the feature: While holding the Valet®/Program button, you can toggle the feature
on and off using the remote transmitter. Pressing the button that arms the system will
select the one chirp or default setting. Pressing the disarm button on a standard configu-
© 1999 Directed Electronics, Inc. Vista, CA
29