Philips Saeco Intelia Service Manual page 68

INTELIA
A
Loosen the screws as illustrated and
remove the boiler pin (A).
F
D
B
Saeco International Group
E
A
B
C
P
H
L
Loosen the screws as illustrated and
remove the gear motor cover.
The following are located inside the compartment pro-
tected by the casing:
- Electric motor (A) with gears (B) and (C) for trans-
mission and timing of the dispenser.
- Dreg drawer presence sensor (D).
- Brewing unit present microswitch (E).
- Microswitch (F) detecting brewing unit home and
work positions.
- Remove the gear (C) that meshes with the motor
transmission shaft.
- Remove the large gear (B).
- Remove the motor (A), complete with transmission
shaft.
Replace the gear (B), making sure that the imprint of
the arrow is aligned with the opening containing the
pin (P).
When replacing the motor and the transmission shaft,
make sure the guide runners (L) are in the right posi-
tion.
Grease the shaft thoroughly and evenly.
Rev. 03
07 DISASSEMBLY
Page / 11
08