Philips Saeco Intelia Service Manual page 45

INTELIA
5.1.3. Test Mode Intelia latte
To enter Test Mode
A) Hold down the Espresso and Milk buttons.
B) Switch on the main switch at the back of the machine.
Press STAND_BY "
Initial status
The letter next to it changes from N to Y only when a button is pressed.
By pressing buttons 1, the display color changes from GREEN to RED.
By pressing buttons 2, the display color changes from GREEN to YELLOW.
By pressing buttons 3,4,5,6,7,8,9, the display color is GREEN.
Button 4 must be pressed at the end only once as when pressed it moves to
the next page.
ERROR condition:
The letters do not change from N to Y or are always Y, in this case check the fl at communication
cable with the power board -Power JP21, if it does not change color check the cable JP4 between
the board and the display.
Press STAND_BY "
Saeco International Group
ESPRESSO
LONG COFFEE
AROMA
SELECTION
MENU
Firmware Software version
Shows the version of the fi rmware loaded.
Insert the brewing unit
" to move to the next screen
The BU-P indicator must change from "N" to "Y"
(this step takes 2-3 sec)
Operational check – keys
ERROR condition:
If the indication does not change, check the brewing unit microswitch and
relative wiring (JP16)
" to move to the next screen
LATTE
MACCHIATO
A
CAPPUCCINO
SPECIAL
Rev. 03
05 TROUBLESHOOTING
MILK
Page
B
/ 22
11