Operating Your Conical Burr Coffee Grinder - Sunbeam EM0450 Instruction Booklet

Heading Operating your Conical Burr Coffee
Grinder
Before using the coffee grinder, wipe the
base exterior with a damp cloth. Wash the
bean hopper, hopper lid and ground coffee
container in warm soapy water, then rinse
and dry.
Note: Do not immerse the burrs in water or
any other liquid.
Note: Do not place any parts of the coffee
grinder in the dishwasher.
1.Place the coffee grinder on a dry, level
surface.
2.To attach the bean hopper, position bean
hopper onto the top of the motor base,
push down and turn clockwise.
See figure 1.
Figure 1
3.Fill the bean hopper with coffee beans.
Tip: Remember to keep the hopper full at
all times. Having an even weight bearing
down on the burrs is important to ensure a
consistent grind.
Note: This coffee grinder is intended to grind
whole coffee beans only.
4.Place the hopper lid onto the bean hopper.
5.Plug the power cord into a 230-240V AC
power outlet and switch the power on.
4
6.Select the grind by turning the grind
adjustment collar to the desired setting,
see figure 2.
Refer to the grind setting table on page 6 to
assist you in selecting the correct grind level
for the desired brewing method.
7. Position the group handle into the group
handle locator, see figure 3.
Note: There are two group handle locators
provided a smaller size to fit domestic
handles and a larger size for commercial
handles.
Figure 2
Figure 3