Barco MatrixPRO 8x8 DVI Quick Start Manual

MatrixPRO 8x8 DVI

Quick Start Guide

Visibly yours
Eight DVI inputs are provided. Use EDID
Resolution Menu to set preferred EDID resolution.
5
1
Input Valid LED
Each input has an associated LED
that lights green to indicate the
presence of a valid video signal.
Quick Install
Signal Connection and Factory Reset
1. Observe all safety precautions. Rackmount chassis, or
install in "tabletop" configuration.
2. Connect outputs from DVI sources to DVI inputs 1
through 8.
3. Connect MatrixPRO outputs 1 through 8 to DVI inputs
on destination devices.
4. (Optional) For Ethernet connection, use a "local"
network only. Connect MatrixPRO's Ethernet Port to
hub. Connect hub to peripheral Ethernet devices.
5. (Optional) For serial connection, connect MatrixPRO's
RS-232 port to external RS-232 device (e.g., PC).
6. Turn power on.
5. (Optional) Perform a factory reset: Main Menu >
Setup > Factory Reset,
SEL
This action cancels all routes, clears all presets, and
resets IP address to default.
DVI Inputs
INPUTS
6 7 8
2 3 4
Common Setup Functions
Set EDID Resolution
1. Main Menu > EDID Setup.
2. Scroll to "Input" line,
3. Rotate ADJUST knob to select individual or all inputs,
4. Scroll to "Format" line,
5. Rotate ADJUST knob to select preferred resolution,
6. Reboot external computers.
Pre-select a Test Pattern
1. Main Menu > Test Pattern.
2. Scroll to "Output" line,
3 Rotate ADJUST knob to select individual or all outputs,
4. Scroll to "Type" line,
5. Rotate ADJUST knob to select a test pattern,
DVI Outputs
Eight DVI outputs
are provided.
OUTPUTS
5 6 7
1 2 3
SEL
SEL
SEL
SEL
SEL
SEL
SEL
SEL
Barco, Inc.
Toll Free: +1 (888) 414-7226
Fax: +1 (916) 859-2515
Technical Support: +1 (866) 374-7878
Website: www.barco.com
Serial Port
For serial communications
and downloading code.
SERIAL
ETHERNET
8
4
100-240V 50-60 Hz
3.0 A
Ethernet Port
For use with external controller
and downloading code.
Common Setup Functions
Enable/disable DHCP
1. Main Menu > Setup > System.
2. Scroll to "DHCP" line,
SEL
3. Rotate ADJUST knob to preferred setting,
Unlock Control Panel
If the panel is locked and it is required that you gain access:
1. Ensure that panel is currently (or temporarily) available
for local use.
2. Press (simultaneously) +
SEL ESC
MatrixPRO 8x8 DVI Router User's Guide
For complete details on all installation and operating
procedures, please refer to the MatrixPRO 8x8 DVI Router
User's Guide.
P/N 26-0503004-00 Rev 02
AC
Connect to AC
power source.
SEL
+
TAKE