Table of Contents
Advertisement
Step 8 — Install Outside Air Hood
Economizer Hood Removal and Setup - -
Factory Option —
1. The hood is shipped in knock- - down form and located
in the return air compartment. It is attached to the
economizer using two plastic tie- - wraps.
2. To gain access to the hood, remove the filter access
panel. (See Fig. 8.)
3. Locate and cut the (2) plastic tie- - wraps, being careful
to not damage any wiring. (See Fig. 9.)
4. Carefully lift the hood assembly through the filter
access opening and assemble per the steps outlined in
Economizer Hood and Two–Position Hood on page 9.
Fig. 8 - - Typical Access Panel Locations
Fig. 9 - - Economizer Wiring
FILTER ACCESS PANEL
INDOOR COIL ACCESS PANEL
C10004
Remove Hood Parts
Cut Plastic Ties
(2) Places
Economizer
C10005
Two Position Damper Hood Removal and Setup - -
Factory Option —
1. The hood is shipped in knock- - down form and
assembled to a metal support tray using plastic stretch
wrap. Located in the return air compartment, the
assembly's metal tray is attached to the basepan and
also attached to the damper using two plastic
tie- - wraps.
2. To gain access to the hood, remove the filter access
panel. (See Fig. 8.)
3. Locate the (2) screws holding the metal tray to the
basepan and remove. In order to remove the screws, it
may be necessary to remove the panel underneath the
two- - position damper. Remove the two screws. Locate
and cut the (2) plastic tie- - wraps securing the
assembly to the damper. (See Fig. 10.) Be careful to
not damage any wiring or cut tie- - wraps securing any
wiring.
4. Carefully lift the hood assembly (with metal tray)
through the filter access opening and assemble per the
steps outlined in Economizer Hood and Two–Position
Hood on page 9.
5. If removed, reattach the panel under the damper.
Fig. 10 - - Damper Assembly
9
Hood Parts
Plastic Tie Wrap
Qty (2)
Screws for Metal Tray
Qty (2)
C10006
Advertisement
Table of Contents
