Instructions For Putting Into Use - Drill Master 92956 Set Up And Operating Instructions Manual

InSTRUCTIOnS FOR pUTTIng
InTO USE
Read the EnTIRE IMpORTAnT
SAFETY InFORMATIOn
section at the beginning of this
manual including all text under
subheadings therein before set up
or use of this product.
FROM ACCIDEnTAL
OpERATIOn:
Make sure the Trigger is in the off
position and unplug the tool from
its electrical outlet before
assembling or making any
adjustments to the tool.
note: For additional information regarding the
parts listed in the following pages, refer
to the Assembly Diagram near the end of
this manual.
Functions
ChUCK KEY
(33)
1. Drill Chuck (3) and Chuck Key (33):
The Close Quarter Drill is equipped
with a 3/8" keyed Drill Chuck (3) that
will accept drill bits (not included) with a
1/16" to 3/8" shank. Installing a drill bit
into the Drill Chuck requires the use of
the accessory Chuck Key (33). Always
make sure the drill bits are firmly secured
in the Drill Chuck prior to using the Drill.
SKU 92956
TO pREVEnT
SERIOUS InjURY
TO LOOSEn
TO TIghTEn
For technical questions, please call 1-800-444-3353.
DRILL
ChUCK (3)
FORWARD/
REVERSE
SWITCh (35)
TRIggER
(30)
TRIggER
LOCK (34)
2. Trigger (30): Squeeze the Trigger to
turn on the Drill and release pressure on
the Trigger to turn off the Drill.
3. Trigger Lock (34):
a continuous run mode, squeeze the
Trigger and depress the Trigger Lock.
Then, release pressure on the Trigger.
The Drill will continue to run.
To turn off the Drill, squeeze and let up
on the Trigger.
4. Forward/Reverse Switch (35):
Forward/Reverse Switch (35) is located
directly above the Trigger (30). Toggle
the switch to change rotation direction.
Use it only after the Drill has come to a
complete stop.
To set the Drill in
The
Page 9