Maintenance And Servicing; Cleaning, Maintenance, And Lubrication - Drill Master 92956 Set Up And Operating Instructions Manual

MAInTEnAnCE AnD
SERVICIng
Procedures not specifically
explained in this manual must
be performed only by a qualified
technician.
FROM ACCIDEnTAL
OpERATIOn:
Make sure the Trigger is in the off
position and unplug the tool from
its electrical outlet before
performing any inspection,
maintenance, or cleaning
procedures.
TO pREVEnT SERIOUS InjURY
FROM TOOL FAILURE:
Do not use damaged equipment.
If abnormal noise or vibration
occurs, have the problem
corrected before further use.
Cleaning, Maintenance, and
Lubrication
1. BEFORE EACh USE,
general condition of the tool. Check for
loose hardware, misalignment or binding
of moving parts, cracked or broken parts,
damaged electrical wiring, and any
other condition that may affect its safe
operation.
2. AFTER USE,
the tool with clean cloth.
Page 12
TO pREVEnT
SERIOUS InjURY
inspect the
wipe external surfaces of
For technical questions, please call 1-800-444-3353.
3. To replace the Carbon Brushes:
may become necessary at sometime to
replace the two Carbon Brushes (19)
when the Motor performance decreases,
or stops working completely.
BRUSh hOLDER
COVER (18)
a. Remove the two Brush Holder Covers
(18).
b. Then, remove the two Carbon Brushes
from the Brush Holders (20).
c. If the Carbon Brushes are worn down
more than 1/2, replace both Carbon
Brushes. If, the Carbon Brushes are
just dirty they may be cleaned by
rubbing them with a pencil eraser.
d. When installing the Carbon Brushes,
make sure the carbon portion of the
Carbon Brushes contact the Motor
Armature, and that the springs face
away from the Motor. Also, make sure
the springs operate freely.
e. After cleaning or replacement, replace
the Brush Holders.
note: New Carbon Brushes tend to arc or
spark when first used until they wear and
conform to the Motor's Armature.
4. WARnIng! If the supply cord of
this power tool is damaged, it must be
replaced only by a qualified service
technician.
It
SKU 92956