Chapter 07
System
Multi Control
MENU
m : T
System
Multi Control
ENTER
Multi Control
ID Setup
ID Input
MDC Connection
RS232C MDC
DisplayPort daisy chain
- The displayed image may differ depending on the model.
Configuring settings for Multi Control
ID Setup
•
Assign an ID to a set. (Range: 0~99)
Press
ID Input
•
Enter the ID number of the product connected to the input cable for input signal reception.
Enter the number you want using the number buttons on the remote control.
00
MDC Connection
•
--
Select a method to connect to MDC to receive the MDC signal.
-
-
Clone
DisplayPort daisy chain
•
To display the DP IN video input through the DP OUT output port, select a device connection method from Single
Stream Transport (SST) and Multi Stream Transport (MST).
Clone: In this Single Stream Transport (SST) output mode, the same screen output is displayed on two display devices
connected.
― If
―
Expand: In this Multi Stream Transport (MST) mode, a different screen output is displayed on two display devices
connected.
― If
― The mode functions only on a PC that supports DisplayPort 1.2 MST.
― For Full HD resolution (1920x1080) displays, a maximum of four displays can be connected.
or
to select a number, and press
.
RS232C
MDC: Communicate with MDC via the RS232C-stereo cable.
RJ45
MDC: Communicate with MDC via the RJ45 cable.
Clone
is selected, the
PC
recognizes the two displays as a single monitor.
Clone
mode is enabled if the input source is a digital input other than DisplayPort, such as DVI, HDMI, MagicInfo.
Expand
is selected, the
PC
recognizes the two displays as separate monitors.
111