Panasonic Lumix DMC-ZR3 Operating Instructions Manual page 207

[SOME PICTURES CANNOT BE COPIED]/[COPY COULD NOT BE COMPLETED]
•
The following pictures cannot be copied.
– When a picture with the same name as the picture to be copied exists in the copy
destination. (Only when copying from a card to the built-in memory.)
–
Files not based on the DCF standard.
•
Moreover, pictures recorded or edited by other equipment may not be copied.
[BUILT-IN MEMORY ERROR
FORMAT BUILT-IN MEMORY?]
•
This message will be displayed when you format the built-in memory on a PC.
 Format the built-in memory on the camera again.
will be deleted.
[MEMORY CARD ERROR
FORMAT THIS CARD?]
•
It is a format that cannot be used with this unit.
 Format the card again with the camera after saving necessary data on a PC etc.
[PLEASE TURN CAMERA OFF AND THEN ON AGAIN]/[SYSTEM ERROR]
•
This message appears when the camera is not operating properly.
 Turn the camera off and on. If the message persists, contact the dealer or your nearest
Service Center.
[MEMORY CARD PARAMETER ERROR]/[THIS MEMORY CARD CANNOT BE USED]
 Use a card compatible with this unit.
•
SD Memory Card (8 MB to 2 GB)
•
SDHC Memory Card (4 GB to 32 GB)
•
SDXC Memory Card (48 GB to 64 GB)
[INSERT SD CARD AGAIN]/[TRY ANOTHER CARD]
•
An error has occurred accessing the card.
 Insert the card again.
 Insert a different card.
[READ ERROR/WRITE ERROR
PLEASE CHECK THE CARD]
•
It has failed to read or write data.
 Remove the card after turning the power [OFF]. Insert the card again, turn the power on,
and try to read or write the data again.
•
The card may be broken.
 Insert a different card.
Others
(P30) The data on the built-in memory
(P17)
- 173 -
(P30)