Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for DeLonghi DW97AU
Summary of Contents for DeLonghi DW97AU
- Page 1 DeLonghi DW97AU...
-
Page 2: Table Of Contents
Dear Customer, Please read this User Information carefully and keep it to refer to at a later date. Pass it on to any subsequent owner of the appliance. Control Panel............3 Dishwasher Features..........3 This manual contains sections of safety instructions, operating instructions, installation instructions and trouble shooting tips . - Page 3 Under certain conditions, Hydrogen gas may be produced in a hot-water system that has not been used for two weeks or more. HYDROGEN GAS IS EXPLOSIVE.If the hot-water system has not been used for such a period, before using the dishwasher turn on all hot-water faucets and let the water flow from each for several minutes. This will release any accumulated hydrogen gas.
-
Page 4: Control Panel
Dispose of the dishwasher packaging material correctly. All packaging materials can be recycled. Plastic parts are marked with the standard international abbreviations: for polyethylene, e.g. sheet wrapping material for polystyrene, e.g. padding material polyoxymethylene, e.g. plastic clips polypropylene, e.g. Salt filler Acrylonitrile Butadiene Styrene, e.g. -
Page 5: Rinse Aid
To get the best performance from your dishwasher,read all operating instructions before using it for the first time. O FF DE LAY ON/OFF Button: To turn on/off the power supply. Display Window: delay time, running indicator, faut codes and etc. Power on light: To come on when Power ON/OFF button is pressed down. - Page 6 Before usi ng your dishwasher for the first time: A. Set the water softener B. Pour 1／2 litre of water inside the salt container and then fill with dishwasher salt C. Fill the rinse aid dispenser D. Function of detergent The water softener must be set manually, using the water hardness dial .
- Page 7 Always use salt intended for use with dishwasher. The sal t container is locat ed beneath the lower rack and should be filled as foll ows: Atte ntion! Only use salt specifically designed for use in dishwa shers! All other t ypes of salt not spe ci fically designed for use in a dishwasher, e specially table salt, will damage the water softener.
- Page 8 You can judge the amount of rinse-aid by the color of the optical level indicator "D" located next to the cap. When the rinse-aid container is full, the whole indicator will be dark .As the rinse-aid diminishes, the size of the dark dot decreases. You should never let the rinse aid get below 1 / 4 full.
- Page 9 Detergents with its chemical ingredients are necessary to remove dirt, dissolved dirt and transport it out of the dishwasher. Most of commercial quality detergents are suitable for this purpose. Concentrated Detergent Based on their chemical composition, dishwasher detergent can be: conventional, alkaline detergents wi th caustic components low alkaline concentrated detergents with natural enzymes The use of “normal”...
- Page 10 Filling the detergent container Fill the detergent dispenser with detergent. The marki ng indicates the dosing levels , as illustrated on right: Place the detergent for the main wash cycle here. Place the detergent for the pre-wash cycle here. Please observe the manufacturers dosing and storage recommendations as stated on the detergent packaging.
-
Page 11: Attention Before Or After Loading The Dishwasher Racks
For best performance of the dishwasher, follow these loading guidelines. Features and appearance of racks and silverware baskets may vary from your model. Attention before or after Loading the Dishwasher Racks Scrape off any large amounts of leftover food. It is not necessary to rinse the dishes under running water. - Page 12 The upper rack is for more delicate and lighter dishware such as glasses, coffee & tea cups, saucers, plates, bowls, and shallow pans (provided these are not too dirty). Position the dishes and cookware so that they do not get moved by the spray of water.
- Page 13 We recommend that you place large items which are most difficult to clean into the low er rack: pots, pans, lids, serving dishes and bowls, as shown in the figure blow. It is preferable to place serving dishes and lids on the side of the racks in order to avoi d blocking the rotation of the top spray arm.
- Page 14 Silverware Basket Silverware should be placed in the silverware basket with handles at the bottom: If the rack has side baskets, the spoon should be loaded individually into the appropriate slots, especially long utensils should be placed in the horizontal position at th e front of the upper rack.
-
Page 15: Possible Causes
When loading the dishes and cutlery, please note: Dishes and cutlery must not impede the rotation of the spray arms Load hollow items such as cups, glasses, pans etc. with the opening downwards so that water cannot collect in the container or a deep base shes and items of cutlery must not lie inside one another, or cover each othe r avoid damage to glasses, they must not touch Load large items which are most difficult to clean into the lower rack... - Page 16 Pre-wash For normally soiled loads, pre-wash such as pots , plates,glasses wash45 ℃ 3in1 and lightly soiled pans. rinse standard daily cycle. rinse68 drying Pre-wash (45℃) For the heaviest soiled loads, wash(50℃ 70℃ such as pots,pans,casserole Rinse Intensive dishes and dishes that have 5/30 g.
-
Page 17: Detergent
Turning on the Appliance Sta rting a wash cycl e... Draw out the lower basket load the dishes and push back. Repeat for the up per basket. It is recommended that you load the lower basket first than the up per one (see the sectio n entitled “L oadi ng the Di sh wash er”) . Po ur in the detergent (see the section entitled “Salt, Det erge nt and Rinse Ai d”). -
Page 18: Filtering System
A forgotten dish can be added any time before the detergent cup opens.Please be careful when opening the door while the dishwasher is in operation as hot water may scald you Open the door a little to stop the washing. Add forgotten dishes. -
Page 19: Caring For The Dishwasher
Filter assembly For best performance and results, the filter assembly must be cleaned. The filter efficiently removes food particles from the wash water, allowing it to be reci rculated during the cycle. For this reason, it is a good idea to remove the larger food particles trapped in the filter after each wash cycle by rinsing the semicircular filter and cup under running water. -
Page 20: Installation Preparation
To clean the edge around the door, you should use only a soft warm, damp rag. To prevent penetration of water into the door lock and electrical components, do not use a spray cleaner of any kind. Also, never use abrasive cleaners or scouring pads on the outer surfaces because they will scratch the fini sh. -
Page 21: Aesthetic Panel's Dimensions And Installation
【Figure1】 90 ° 90 ° Cabinet dimensions Less than 5mm between the top 820mm of dishwasher and 580mm cabinet and the Electrical, drain and water supply line outer door aligned entrances to cabinet. Space between cabinet bottom and floor 600 mm 【Figure2】... - Page 22 Install the hook on the aesthetic wooden panel and put the hook into the slot of the outer door of dishwasher(see figure 4a). After positioning of the panel , fix the panel onto the outer door by screws and bolts(See figure 4b) . Hop hook 【Figure4a】...
-
Page 23: Tension Adjustment Of The Door Spring
Tension adjustment of the door spring ● The door springs are set at the factory to the proper tension for the outer door. If aesthetic wooden panel are installed, you will have to adjust the door spring tension. Rotate the adjusting screw to drive the adjustor to strain or relax the steel cable(see figure 5). -
Page 24: Dishwasher Installation Steps
Dishwasher installation steps ● Install the furniture door to the outer door of the dishwasher using the brackets provided. Refer to the template for positioning of the brackets. Adjust the tension of the door springs by using an Allen key turning in a clockwise motion to tighten the left and right door springs. -
Page 25: Installation The Plinth
Installation the plinth ● 1 Unscrew the tw screws and remove the plinth from the dishwasher. [Figure 8a] plinth [Figure 8a] screw 2 Unscrew the two screws and adjust the distance of left and right plinth tab to your need. The adjustable range is from 39mm to 134mm. - Page 26 Dishwasher must be level for proper dish rack operation and wash performance. Place level on door and rack track inside the tub as shown to check that the dishwasher is level. level the dishwasher by adjusting the four leveling legs individually. When level the dishwasher, pl s pay attention not to let the dishwasher tip ea e forwar .
- Page 27 The appliance must be connected to the water mains using new hose-sets. The old hose-sets should not be reused. Water pressure must be between 0.04 MPa and 1 Mpa. Pull The safety supply hoses completely out from storage compartment located at rear of dishwasher. Tighter the screws of the safety supply hose to the faucet.
-
Page 28: Start Of Dishwasher
Start of dishwasher ● The followings should be checked before starting the dishwasher. The dishwasher is level and fixed The inlet valve is opened There are no leaks The electrical plug and lead is undamaged and connected to the socket correctly The inlet and drain hoses are not knotted or twisted in any way that will effect the water supply The inlet and drain hoses are knotted All packing materials and printings should be taken out from the dishwasher... -
Page 29: Before Calling For Service
Before Calling for Service Review the charts on the following pages may make you be free of calling for service. Fuse blown, or the Replace fuse or reset circuit breaker. Remove any other circuit breaker acted appliances sharing the same circuit with the dishwasher Make sure the dishwasher is turned on and the door is Power supply is not turned on... - Page 30 Combination of soft Use less detergent if you have soft water and select a water and too much shortest cycle to wash the glassware and to get them clean. detergent Tea or coffee stains using a solution of 1/2 cup of bleach and 3 cups warm water to remove the stains by hand.
- Page 31 Height : 820mm(adjustable+10mm) Width : 595mm Depth : 560mm Voltage connected Load : see rating label Water pressure: 0.04-1.0MPa Hot water connection : max 60 ℃ Power supply: see rating label Capacity: 14 Place settings...
Need help?
Do you have a question about the DW97AU and is the answer not in the manual?
Questions and answers