Download  Print this page

Husqvarna 325HDA55X-Series, 325HE3X-Series, 325HE4X-Series, 323HE3 Operator's Manual

Husqvarna electric hedge trimmer operator's manual.
Hide thumbs

Advertisement

325HDA55
325HE3
325HE4
Operator's Manual
Please read these instructions carefully and make sure
you understand them before using the hedge trimmer.
X-SERIES
X-SERIES
X-SERIES
(EPA)
114 00 06-95

Advertisement

   Related Manuals for Husqvarna 325HDA55X-Series, 325HE3X-Series, 325HE4X-Series, 323HE3

   Summary of Contents for Husqvarna 325HDA55X-Series, 325HE3X-Series, 325HE4X-Series, 323HE3

  • Page 1

    325HDA55 325HE3 325HE4 Operator's Manual Please read these instructions carefully and make sure you understand them before using the hedge trimmer. X-SERIES X-SERIES X-SERIES (EPA) 114 00 06-95...

  • Page 2: Symbol Explanation

    SYMBOL EXPLANATION Symbols WARNING! The hedge trimmer can be dangerous! Careless or incorrect use can result in serious, even fatal injury. Read through the Operator‘s Manual carefully and understand the content before using the hedge trimmer. Always use • Ear protection •...

  • Page 3: Table Of Contents

    Husqvarna AB has a policy of continuous product development and therefore reserves the right to modify the design and appearance of products without prior notice. Maintenance, replacement, or repair of the emission control devices and systems may be performed by any nonroad engine repair establishment or individual.

  • Page 4: Safety Instructions

    SAFETY INSTRUCTIONS Personal protective eqipment IMPORTANT INFORMATION • Incorrect or careless use of a hedge trimmer can turn it into a dangerous tool that can cause serious or even fatal injury. It is extremely important that you read and understand this manual.

  • Page 5

    SAFETY INSTRUCTIONS 4. Vibration damping system The hedge trimmer is equipped with a vibration damping system, which is designed to give as vibra- tion-free and comfortable use as possible. The hedge trimmer’s vibration damping system reduces the transfer of vibrations between the engine unit/blades and the hedge trimmer’s handles.

  • Page 6: Control, Maintenance And Service Of The Hedge Trimmer's Protective Equipment

    Control, maintenance and service of the hedge trimmer’s protective equipment IMPORTANT INFORMATION • All service and repairs to the machine require special training. • This applies especially to the machine‘s safety equipment. If the machine does not meet any of he controls listed below you should contact your service workshop.

  • Page 7

    • Replace the blade guard if it is bent or damaged. 8. Gearbox • The gearbox gets hot when the hedge trimmer is in use. To avoid burning yourself do not touch the gearbox. English –...

  • Page 8: General Safety Instructions

    Contact your local petrol station to find out how to dispose of excess fuel. • The blades transport guard should always be fitted when transporting or storing the hedge trimmer. WARNING! Exercise great care when handling fuel.

  • Page 9: General Working Instructions For Hedge Trimmer

    Safety instructions when using the hedge trimmer WARNING! The hedge trimmer can cause serious personal injury. Read the safety instructions carefully. Learn how to use the machine. WARNING! Cutting tool. Do not touch the tool without first switching off the engine.

  • Page 10: Basic Working Techniques

    – English SAFETY INSTRUCTIONS Changing the hedge trimmer angle (325HE3, 325HE4) • Loosen the knob on the angle adjuster. • Grasp the handle on the...

  • Page 11: What Is What

    325HE4 What is what on the hedge trimmer? 1. Blade 2. Grease nipple (3) 3. Gearbox 4. Blade guard (325HDA55) 5. Shaft 6. Front handle(325HDA55,325HE3) 7. Front handle(325HE4) 8. Throttle trigger 9. Stop switch 10. Throttle trigger lock 11. Harness hook (325HE4) 12.

  • Page 12: Assembly

    3. Fit the long screw, washers and knob. – English ASSEMBLY Fitting the cutting attachment Lay the hedge trimmer on a flat surface before fitting the cutting attachment. Other- wise the cutting attachment may not be fitted straight. 1. Fit the cutting attachment to the shaft.

  • Page 13: Fuel Handling

    HUSQVARNA’s small, two-stroke engines. Mixing ratio 1:50 (2%). • If HUSQVARNA two-stroke oil is not available you can use a high quality two-stroke oil intended for air cooled engines. Contact your dealer when selecting an oil. Mixing ratio: 1:33 (3%).

  • Page 14: Start And Stop

    Always move the hedge trimmer about 3 metres from the filling position before starting. Place the machine on a flat surface. Bear in mind that the blades start to move when the engine is started.

  • Page 15: Maintenance

    Carburettor Your Husqvarna product has been designed and manufac- tured to specifications that reduce harmful emissions. After your unit has been run 8-10 tanks of fuel the engine has broken in. To ensure that your unit is at peak perform-...

  • Page 16

    Adjusting the idle speed, T Adjust the idling speed with the screw T, if it is necessary to readjust. First turn the idle speed adjusting screw T clockwise until the cutting attachment starts to rotate/ move. Then turn, counter-clock- wise until the cutting attachment stops.

  • Page 17: Muffler

    Muffler NOTE! Some mufflers are fitted with catalytic converters. See “Techni- cal data” to find out if your machine is equipped with a catalytic converter. The muffler is designed to dampen the noise level and to direct the exhaust fumes away from the user.

  • Page 18: Air Filter

    If the machine is used in dusty conditions the air filter should be soaked in oil, see the section on “Oiling the air filter“. Oiling the air filter Always use HUSQVARNA filter oil, order no. 503 47 73-01. The filter oil con- tains a solvent to make it spread evenly through the filter.

  • Page 19: Maintenance Schedule

    Maintenance schedule Below you will find some general maintenance instructions. Daily maintenance • Check throttle trigger and throttle trigger lockout function. • Check stop switch function. • Check that the blades do not rotate while idling or when the choke is in the start position. •...

  • Page 20: Technical Data

    Technical data Engine Cylinder capacity, cu. in/cm Cylinder bore, inch/mm Stroke length, inch/mm Idling speed, rpm Recommended max. speed, rpm Max speed, should not be exceeded, rpm Max. engine output, acc. to ISO 8893 Catalytic converter muffler Speed-regulated ignition system Ignition system Manufacturer/type of ignition system Spark plug...

  • Page 21: Emission Control Warranty Statement

    REPAIR OR REPLACEMENT OF PARTS Repair or replacement of any warranted part will be perfor- med at no charge to the owner at an approved Husqvarna Forest & Garden servicing dealer. If you have any questions regarding your warranty rights and responsibilities, you should contact your nearest authorized servicing dealer or call Husqvarna Forest &...

  • Page 22

    ´+HÆe¶5d¨ – English...

  • Page 23

    English –...

  • Page 24

    ´+HÆe¶5d¨ 2001W10...

Comments to this Manuals

Symbols: 0
Latest comments: