Husqvarna 325HDA55X-Series, 325HE3X-Series, 325HE4X-Series, 323HE3 Operator's Manual page 16

Adjusting the idle speed, T
Adjust the idling speed with
the screw T, if it is necessary
to readjust. First turn the
idle speed adjusting screw T
clockwise until the cutting
attachment starts to rotate/
move.
Then turn, counter-clock-
wise until the cutting
attachment stops. A correctly
adjusted idle speed setting
occurs when the engine runs
smoothly in every position.
It should also be good
margin to the rpm when the
cutting attachment starts to
move.
CAUTION! Contact your servicing dealer, if the idle speed
setting cannot be adjusted so that the cutting attachment
stops. Do not use the machine until it has been properly
adjusted or repaired.
High speed needle H
The high speed needle
affects the machine's power,
speed, temperature and fuel
consumption. A too lean
adjustment on the high
speed needle H (the high
speed needle H is screwed
in too much) gives a too
high speed resulting in
engine damage. Do not
allow the engine to run at
full speed for more than 10
seconds.
Apply full throttle and turn
the high speed needle H
slowly anticlockwise until
the engine runs unevenly.
The high speed needle H is
then turned slowly clock-
wise a little until the engine
runs smoothly.
Note the engine should be
run unloaded when
adjusting the high speed
needle. Therefore disman-
tle the cutting equipment,
nut, support flange and disc
drive before adjusting the
high speed needle. The high
speed needle is adjusted correctly when the machine 'splatters'
a little . If the machine smokes heavily at the same time as it
'splatters' heavily the adjustment is too rich.
NOTE! For optimum setting of the carburettor, contact a
qualified servicing dealer who has a revolution counter at his
disposal.
16
– English
MAINTENANCE
+ 1/4
L
H
Correctly adjusted carburettor
A correctly adjusted carburettor means that the machine
accelerates without hesitation and the machine 4-cycles a little
at max speed. Furthermore, the cutting attachment must not
rotate/move at idling. A too lean adjusted low speed needle L
may cause starting difficulties and bad acceleration.
A too lean adjusted high speed needle H gives lower power =
less capacity, bad acceleration and/or damage to the engine.
A too rich adjustment of the two speed needles L and H gives
acceleration problems or too low working speed.