Completing The Set Up - Samsung Refrigerator User Manual

3. Push the installed CO cylinder fully into the cylinder case.
2
4. To lock the CO cylinder, push the safety lever down.
2
• The lever may be stiff due to the internal pressure of the CO
hold the lever as shown by the fi gure on the right and press it down fi rmly.
• If you do not lock the CO
2
• If the CO cylinder is not fi rmly connected to the regulator, CO
2
a "hissing" sound. In this case, repeat step 2, 3 and 4 to properly install the CO
cylinder.
5. The sparkling water concentration is set to '2' by default. Press the "Sparkling Water" button to set the
concentration to a desired level and hold down the "Sparkling Water" button for 3 seconds to reset the CO
cylinder. Once the CO cylinder is reset, sparkling water is produced.
2
• To produce sparkling water, the sparkling water tank is fi lled with water and the CO
the confi gured concentration.
• To remove foreign substances that may exist in the sparkling water tank, discard the fi rst 1.2L of sparkling water.
• The sparkling water will not dispense while it is producing. When the numbers (
icon stops blinking, Sparkling water can be dispensed.
• To Uninstall the CO cylinder, follow the above step #1 ~ #4 in reverse order.
2
For more information about using the Sparkling Water function, see Using the Sparkling Water Function.

Completing the Set Up

Now that you have your new refrigerator installed in place, you are ready to set up and enjoy the
features and functions of the appliance. By completing the following steps, your refrigerator should be
fully operational.
1. Make sure your refrigerator is in an appropriate location with reasonable clearance between it and
the wall. Refer to installation instructions in this manual.
2. Once the refrigerator is plugged in, make sure the interior light comes on when you open the doors.
3. Set the Temperature control to the coldest temperature and wait for an hour. The freezer will get
slightly chilled and the motor will run smoothly. Reset the refrigerator and freezer to the temperatures
you want.
4. After you plug the refrigerator in, it will take a few hours to reach the appropriate temperature. You
can store food and drinks in the refrigerator after the temperature is suffi ciently cool.
If condensation or water drops appears on both sides of fridge door's central part, turn the
Energy Saver mode off after removing the condensation. (See the explanation on Energy Saver
button in the USING THE CONTROL PANEL.)
cylinder, the sparkling water maker will not work.
Press 3 seconds Press 3 seconds
cylinder. In this case,
2
gas may leak with
2
2
gas is injected according to
2
) next to the sparkling water
2
setting up _25