Samsung Refrigerator User Manual page 50

2. Pull the Cylinder out of the Support.
3. Rotate the Cylinder
counterclockwise to remove it from
the Regulator.
4. To install the new cylinder, follow the directions for
installing a cylinder starting at Step 2.
5. Press the Sparkling Water button for 3 seconds to
turn the Cylinder reset function on.
• If you replace the CO Cylinder during Sparkling
2
Water Production (The Carbonation Level Icon turns
on in the order of 1 → 2 → 3 → 1.), wait until the
refrigerator completes production before turning
the Sparkling Water Production function back on.
Because you interrupted production, the sparkling
water may be over carbonated. We recommend that
you throw out the overly carbonated water.
Operational Notes
• Be sure to use genuine Soda Stream Cylinders
from authorized resellers.
• The refrigerator starts making sparkling water
about 10 seconds after you turn on the
Sparkling Water Production function.
• If you open the refrigerator door while the
refrigerator is making sparkling water, it will
stop. When you close the door, it will resume
making sparkling water in about a minute.
• If there is a power interruption when the
refrigerator is making sparkling water, the
refrigerator may re-start the carbonation
process when power returns and put too
much carbonation into the water. If this occurs,
we recommend throwing out the overly
carbonated water and starting the process
again.
• If you keep dispensing sparkling water, the
water stream may become unstable or break
up. This is caused by changes in pressure in
the Sparkling Water Production Tank. It is not
a defect.
• If the water hose is kinked or water is not
50_ operating
supplied properly, the Carbonation Level of
the Sparkling Water will be high. This occurs
because the the same amount of the carbon
dioxide (CO ) is dispensed by the Cylinder
2
regardless of the amount of water in the
Production Tank.
• The useful life of the Cylinder will vary,
depending on the level of carbonation you
select.
• If you are not going to be home for a long
period of time, do not want to use the
Sparkling Water function any more, or you are
moving:
• Please remove the CO
the compartment located in the left door
CAUTION
of the refrigerator before you transport
the refrigerator.
1. Press the Cubed/Crushed button for three
seconds to turn off the Sparkling Water
function.
2. Empty the Sparkling Water tank by dispensing
all the water in the tank.
3. Remove the CO Cylinder.
2
carbonator from
2