Samsung Refrigerator User Manual page 18

With the door opened
1. Remove the 3 screws holding down the TOP
TABLE ( 1 ) and separate the connected wires.
2. Disconnect the two connectors ( 2 ) on the
left side door. To remove the water coupler
from the hinge, twist and pull it from the hinge.
Remove the water line ( 3 ) while pressing the
marked part ( 4 ) of the water line coupler.
If a red clip is on the coupler, you must
remove it before removing the tube.
CAUTION
2
Red Clip Red Clip
(1/4") (1/4")
3
4
3. Pull and remove the hinge lever ( 5 ). Remove
the ground screw ( 6 ) attached to the upper
left door hinges with a philips screwdriver (+).
Remove the upper left and right door hinges
( 7 ).
5
7
4. Open the door (more than 90°), lift from the
middle hinge and remove the door.
- Due to its design features, you can
disassemble and re-assemble the door when
the door is open. (The holes in the Door Shaft
and the Door Middle Hinge are deliberately
tilted at specifi c angles so that it is diffi cult to
disassemble and re-assemble with the door
18_ setting up
closed.)
1
CAUTION
- If the Auto Closing Hinge is aligned to be
vertical as shown in the fi gure, align it to be
parallel by using the Door Middle Hinge. (Refer
to No.5 for the disassembly of the Door Middle
Hinge)
CAUTION
6 5. Remove the screw ( 8 ) attached to the
lower left and right door hinges with a philips
screwdriver (+). Remove the 2 hex head bolts
( 9 ) attached to the lower left and right door
hinges with an allen wrench (5 mm). Remove
the lower left and right door hinges ( 10 ).
Place the door, inside facing up, on a non-
scratching surface.
Door Middle Hinge Door Middle Hinge
Auto Closing Hinge Auto Closing Hinge
Check the direction Check the direction
Do not use a fl at head screwdriver to align
the Auto close Hinge. It may get damaged.
Use the Door middle Hinge instead.
10
8
9
Allen wrench Allen wrench