Char-Broil American Gourmet 12301567 Product Manual page 12

9
Place Grill Lid on top of firebox assembly. Align hinge holes on back of unit. With the aid of a helper, attach Grill
Lid to firebox using 2 each Hinge Pins. Once Hinge Pins are in place, insert Large Hair Pin Clip into hole in
Hinge Pin.
Next, install Smokestack by inserting 2 each 1/4-20x3/4 screws though Grill Lid, insert Smokestack into Grill Lid
hole, then secure using 2 each 1/4-20 flange nuts.
Attach Handle to Grill Lid, secure with 2 each 1/4-20 Flange nuts and 2 lock washers.
Hinge Properly Installed
Hinge Pin
10
Install the Swing-Away Grate by inserting 2 each 1/4-20x2" screws (one for each side of the lid) into Grill Lid and s
with 2 each 1/4-20 flange nuts.
Similarly secure the Swing-Away leg to the firebox using 2 each 1/4-20x3/4" screws and 2 each 1/4-20 flange nuts.
Wire Loop
1/4-20
Flange Nut
Page 12
Hair Pin Clip
Hinge Pin
Place the wire loop in Swing-Away over the shaft of the bolt, as shown below.
1/4-20x2"
Screw
Swing-
Away Leg
1/4-20x3/4"
Screw
Lock Washer
1/4-20 Flange Nuts
Damper Wheel
1/4-20
Flange Nut
Lock Washer Flat Washer
Attach the butterfly damper wheel to the firebox using 1 each
1/4-20x3/4" screw, 2 each flat washers, 1 lock washer and
one 1/4-20 flange nut. DO NOT FULLY TIGHTEN THE
FLANGE NUT. This will allow for rotation of the damper wheel.
Handle with
Barrel Spring
1/4-20x1/2
Screws
1/4-20x 3/4 Screw
ecure
Flat
Washer