Pre-Operation Inspection; Operations - Jet AB-1012W Operating Instructions And Parts Manual

12.0 Pre-Operation Inspection

Before proceeding with cut, verify the following:
• Blade style/size is proper for the job at hand.
• Blade has proper tension.
• Blade guide post is secured.
• Wire brush is properly positioned.
• Coolant is clean, and at sufficient level.
• Coolant flow rate is sufficient.
• Work piece is clamped securely.
• All safety rules under the Warning section in
this manual have been followed.

13.0 Operations

Before operating the band saw, thoroughly
familiarize yourself with the functions of the control
panel, shown on page 23.
The Band Saw will automatically shut off power if
left inactive for five minutes while the hydraulic
pump is on. To restart the machine, turn on the
hydraulic pump.
In the event of an emergency, press the
Emergency Stop Button, or press the Bow Up
button, to stop machine functions. When the Bow
Up button is used, the workpiece will remain
clamped. When the Emergency Stop button is
used, all machine functions are canceled.
During operations in Auto Mode, you can also stop
the saw by turning switch (J, Figure 32) to Manual
Mode; the band saw will complete its current task
and then halt.
Figure 26
Figure 27
Figure 28
17