Removal And Replacement - Evaporator - Scotsman CS0415 Service Manual

Removal and Replacement - Evaporator

Electrical Shock Hazard
Electrical shock can
cause personal injury.
Disconnect electrical
power before proceeding.
Evaporator
1. Unplug ice maker or disconnect power.
2. Open the ice maker door.
3. Remove the ice from the storage bin.
4. Remove the cutter grid and the evaporator
thermistor from the unit.
5. Disconnect the bin thermistor connector from the
bottom of the control housing.
6. Remove the top door screw from the ice maker
door, and pull the door off the bottom hinge.
7. Remove the two 5/16" hex-head screws from the
top hinge and remove the hinge.
8. Remove the two front and two rear screws from
the cabinet top.
Lift the cabinet top and position it forward on top of
the unit.
From the rear of the unit, remove the six hex-head
screws from the channel cover and remove the
cover.
12. Remove the four screws from the unit
compartment cover and remove the cover.
13. Cut the tie wrap from around the tubing and
wire harness inside the channel.
Unit
Compartment
Cover
July 2007
Page 23
CS0415
Service Manual
Channel
Cover