Aviom A-16II User Manual page 48

Problem:
Can't hear a channel that is part of a Group
Possible Solutions:
• The Group might be muted. Check the lower (yellow) LED
in the channel buttons. A lit yellow LED indicates the chan‑
nel is muted. To unmute it, press the M
Group is selected. The yellow LED must be unlit in order to
hear the audio on that channel.
• The channel volume is all the way down. In Group edit
mode, select the channel and check the level for that chan‑
nel by looking at the LEDs in the Volume indicator. If no
LEDs are lit, then the channel is turned all the way down.
Raise the volume by turning the channel V
re‑save the Group and Preset if necessary.
Problem:
The A-Net LED is on, but there is no sound
Possible Solutions:
• The A‑Net Active LED indicates that the input to the receiv‑
ing device is properly connected to another A‑Net device.
It does not indicate that all devices in a system are properly
connected, however. If you have two Personal Mixers
connected together, the second Personal Mixer's A‑Net
LED will light because the first Personal Mixer is correctly
connected to it. Check that each device in the chain has a
Cat‑5 cable plugged into it.
• Check that the A‑Net cables are connected in the correct
order. The Cat‑5 cable connected to the first Personal Mixer
should be connected to the A‑Net In jack. The next device
is connected from the A‑Net Out on the first device to the
A‑Net In on the next.
Problem:
A Preset was saved with a stereo link active but when the Preset is
recalled the channels are mono. (Or, a Preset was saved with mono channels, but
on recall the channels are linked.)
Possible Solutions:
• The status of the stereo link is set by the Link switches on
the input module. If a Preset is recalled and the position
of the Link switch is different from when the Preset was
saved, the Preset will be adjusted to agree with the current
settings on the input module's front panel. If this happens,
simply change the position of the Link switch on the input
module. Your current mix will be updated immediately.
A-16ii P M U G
ersonAl ixer ser Uide
button while the
ute
knob;
oluMe
40