Held Solo Mode - Aviom A-16II User Manual

Two solo modes are available, indicated with a solid or flashing LED in the button.

Held Solo Mode

This Solo mode allows channels to be soloed in succession without exiting
the Solo Mode. This is in addition to the regular Solo Mode behavior
described above that allows the user to exit Solo Mode by pressing any other
interface button after soloing a channel. Held Solo Mode is indicated by the
flashing of the Solo LED.
To use Held Solo Mode, you must start from Mix Mode (that is, no channels
are currently soloed). The Recall, Group, and Solo LED's should be off.
To use Held Solo Mode:
• Press and
• While holding down the
release any channel button.
• You can now release the
S button before releasing the channel button, Held Solo
olo
will not be engaged.)
• The channel that you pressed is now soloed, and the Solo
LED is flashing.
• To solo another channel, press its channel button.
• To exit Held Solo Mode, press the
You can also exit Held Solo Mode by pressing the R
buttons.
Remember that the Personal Mixer can only enter Held Solo Mode from the
normal Mix Mode. If you currently have a channel temporarily soloed (the
Solo LED is lit solid), you must exit the single channel Solo Mode (by hitting
another channel button or the S
Mode.
A-16ii P M U G
ersonAl ixer ser
hold the S
button.
olo
S
olo
S
olo
olo
Uide
button, press and then
button. (If you release the
S
button again.
olo
button) before you can enter Held Solo
, G , or M
ecall Roup ute
24