Table of Contents
Advertisement
Pairing the remote control
Throttle
Pairing the Remote
Before you can fly, you need to 'pair' the helicopter and remote together. To do this:
•
turn on both the helicopter and remote
•
select a frequency using the band selector switch. If flying multiple helicopters, ensure
each is on a different band
1.
slide the throttle
control to minimum
Band Selection
This is a two channel IR helicopter. This means that two helicopters can be used at the same
time, provided they are paired to different bands.
The switch in the upper centre of the controller selects bands. You can choose either BAND A
or BAND B.
If using two helicopters at once:
•
Ensure that one controller is set to BAND A and the other set to BAND B.
•
Pair the helicopters very carefully. For best results, pair each helicopter in separate rooms.
•
Ensure that they aren't within line of sight of one another when pairing.
•
If you're only using one helicopter, you can use either BAND A or BAND B.
•
If the controller is interfering with any other devices, or other devices are interfering
with the helicopter, try changing control bands.
6
IR Transmitter LEDs
IR Band Selector
2.
aim the controller's IR transmitter at the helicopter
3.
move the throttle from minimum to maximum (bottom to
top) and back again. The helicopter will now be paired to
that controller.
Power
Indicator LED
Flight Control
Power Switch
Rotational Trim Control
Advertisement
Table of Contents
