Operation; Power-Up Procedure; Operation Power-Up Procedure - Audio Research VSi75 User Manual

10

Operation

Power-up Procedure

Make sure you have read and complied with the Installation and Connection
instructions prior to attempting operation.
Press the "Power" switch. The Audio Research logo will appear for a few
seconds, then "Mute" will flash and a numeric countdown will show on the
LCD display while power supply stabilizes, indicating operation of automatic
muting circuit. After this automatic muting period the LCD display will show
the normal operating screen, and "Mute" will no longer be flashing. Adjust
the Volume control to the minimum level as indicated by the front panel LCD
display. When the "Mute" button is pressed, "Operate" will show on the
LCD display, indicating the VSi75 is ready for operation.
Note: If the LCD display does not illuminate after pressing the power
button, check the appropriate fuse for failure. An extra fuse for A.C. power
is included with your VSi75.
Press Input selector for desired source; set remaining switch options to
desired positions.
Activate selected input source, then deactivate Mute switch and adjust
Volume control as necessary.
Your VSi75 should now operate satisfactorily. However, a full stabilization or
warm-up time of approximately one hour is recommended for best sonic
performance.
Shut-Down
Set Mute switch to "Mute" position.
Adjust Volume control to minimum setting.
Press the "Power" button to shut unit off.