Related Manuals for Audio Research VS55
Summary of Contents for Audio Research VS55
- Page 1 Owner’ s Manual Model VS55 STEREO POWER AMPLIFIER 3900 ANNAPOLIS LANE NORTH / PLYMOUTH, MINNESOTA 55447-5447 / PHONE: 763-577-9700 FAX: 763-577-0323 www.audioresearch.com...
-
Page 2: Table Of Contents
Contents 12-17-07 VS115 Manual / 8-07 / Model VS55 Section Page No. Preface ............. . 1 Packaging . -
Page 3: Model Vs55
Model VS55 5 -01 VS55 Manual / 8-07 / ® MODEL VS55 HIGH DEFINITION P O W E R VACUUM TUBE AMPLIFIER C A U T I O N FOR PROTECTION AGAINST FIRE HAZARD MODEL VS55 REPLACE ONLY WITH SAME RATED FUSES. -
Page 4: Preface
2. If you are using the optional tube cover, be sure the VS55 unpacking and preparation for use. is first turned off and then remove the top plate with the phillips screwdriver provided with the tube cover. -
Page 5: Installation
For the very best sonic performance on domestic 100 or It is normal for a vacuum tube power amplifier to run quite 120 volt circuits, the VS55 should be connected to its own warm, and if used for prolonged periods,hot to the touch. -
Page 6: Remote Turn-On Connections
Audio trol signal. Research Customer Service at (763)-577-9700. The front power rocker switch on the VS55 must be off to Output Tube Bias Adjustment use the remote turn-on. The front power rocker switch may still be used when the remote turn-on is connected, but the As shipped from the factory, the output “bias”... -
Page 7: Disposal And Recycling Guidelines
TUBES REQUIRED: 2 – Matched pair 6550EH – Power Output; 3 – 6N1P input and driver. ity of the importer is required, Audio Research will fulfill the terms and conditions of the Limited Warranty. Such DIMENSIONS : 14" (35.6 cm) W x 7" (17.8 cm) H x 14"... - Page 8 Model VS115...
- Page 9 Limited Warranty. Such product must be returned at the purchaser's expense to the Audio Research factory, along with a photocopy of the dated purchase receipt for the product, a written description of the problem(s) encountered, and any infor- mation necessary for return shipment.
- Page 10 Preface Please take time to carefully read and understand the following instructions before you install or attempt to oper- ate this equipment. Becoming familiar with the product and its correct operating procedures will help assure you of maximum musical enjoyment and reliable operation. The effort you invest now will be well rewarded in the years ahead Packaging...
- Page 11 Audio Research cannot emphasize this switch. enough. As better components and systems are developed, it becomes increasingly important to avoid the limitations N o t e : Audio Research does n o t recommend leaving your of inferior system interconnections.
- Page 12 Input Connections Warning: It is important sonically that your entire system be To avoid stress and possible damage to the output connected so that the audio signal arriving at the speakers tubes, do not connect or disconnect input cables to has correct, or “absolute”...
- Page 13 1. Make sure you have read and complied with the IN- tors for some time. Refer any needed service to your autho- STALLATION AND CONNECTION instructions prior to rized Audio Research dealer or other qualified technician. attempting operation. Replacement vacuum tubes may be obtained through your 2.
- Page 14 Limited Warranty. Such product must be returned at the purchaser's expense to the Audio Research factory, along with a photocopy of the dated purchase receipt for the product, a written description of the problem(s) encountered, and any infor- mation necessary for return shipment.