Frigidaire Kingston KSF-1/0301 Important Instructions & Operating Manual page 5

No flame effect
Replacing the Lamp

This fireplace consists 1 bulb that illuminates flame effect. Light bulb needs to be replaced if you
notice a dark section of the flame or when the flames lose clarity.
 Warning - Always disconnect from the power outlet before removing bulbs, to reduce the risk of
fire, electric shock or damage to property.

Warning - The bulb reaches high temperatures during operation. Allow it to cool down before
replacing it.

Access the bulb panel located on the rear panel of the fireplace (see fig)

Remove screws, and slide the panel lid off.

Replace the bulb with a new. Extra caution should be taken, as the bulb could be very hot.

Replace the panel lid using screws.
 Warning – Do not use fireplace without putting the lid in place.
Clean & Maintenance

Disconnect from the power supply before attempting any maintenance or cleaning, to reduce
the risk of fire, electric shock to persons or damage to property

Warning - Always disconnect from the power supply before cleaning fireplace

For general cleaning use a soft clean duster-never use abrasive cleaners. The glass viewing
screen should be cleaned carefully with a soft cloth. DO NOT use proprietary glass cleaners.
Technical Specification

Supply: 110-120V, 60Hz
 Rated Power: 1350W

Lighting: Max 40W E12 (small) bulb (1 bulb)
· Check if the unit is plugged in the power port
· Check if the unit is in Standby mode. Turn the
unit ON.
5