Advertisement
Signal distribution from a Satelllite Receiver
Please Note: To view output from the satellite RF2 output you will need a TV with an analogue tuner.
1. Connect your UHF aerial downlead to the aerial
input on your Satellite Receiver and connect your
FM aerial downlead (if applicable) to the IN FM
socket on the SLxB.
2. Connect an aerial fly-lead from the RF2 output
on the Satellite Receiver to the ANT input on the
amplifier.
3. Connect your TVs and FM tuners to any of the
SLxB TV sockets in any combination.
Once connected, you can tune each television
to digital terrestrial channels* and a channel for
satellite viewing.
Aerial
Digi-Eye
TV
TV
TV
Satellite Receiver
Aerial IN
RF1
Dish IN
RF2
Digi-Link
Note. Only one satellite channel can be viewed at
any one time without the use of additional satellite
receivers and subscriptions.
Note. To operate your digital satellite receiver from
one of the connected TVs you will now need to
install a Link device such as the SLx Link.
Note. To view digital terrestrial channels an aerial
must be connected to the Aerial IN socket on the
satellite. Also connected TVs must have a built-in
Freeview™ receiver or be connected to the amplifier
via a Freeview™ set top box.
Satellite
Dish
HDMI/SCART
connection
Note: Digi-Link and Leads
shown are not Supplied
MAIN
TV
DAB Radio/Tuner
TV
DAB
Aerial
Advertisement
