Advertisement
Quick Links
27820BMG
Introduction
Special features include:
•
4G Ready - built-in filter removes interference and channel loss caused by 4G
mobile phone signals
•
Dedicated inputs for UHF and FM/DAB
•
Side mounted terminals provide easy cable management
•
Infra-red by-pass for digilinks
The SLxB series amplifiers are designed to improve the
picture and sound quality of TV and FM radio signals
and distribute these signals around your home.
All SLxB amplifiers have an integrated by-pass
designed to allow the user to control digital satellite
receivers from a second TV without additional
equipment apart fron a Link device and a digital
satellite or compatible universal remote control.
Please Note: To view output from the satellite RF2
output you will need a TV with an analogue tuner.
Careline: 08457 573 479 - (Local Rate UK only)
4 Way Aerial Amplifier
with digital bypass
USER GUIDE
For added safety the SLxB series has built in short
circuit protection on each individual output. Should
a short circuit be detected the SLxB amplifier will only
shut down the output with the short circuit; the other
outputs will continue to function as normal.
The amplifiers are easy to install and fully automatic in
operation, meaning that no user adjustment is required.
The low running cost permits continuous operation.
Support: www.philex.com/support
Ready
Advertisement
Related Manuals for SLX 27820BMG
Summary of Contents for SLX 27820BMG
-
Page 1: User Guide
4 Way Aerial Amplifier Ready with digital bypass 27820BMG USER GUIDE Introduction Special features include: • 4G Ready - built-in filter removes interference and channel loss caused by 4G mobile phone signals • Dedicated inputs for UHF and FM/DAB •... - Page 2 Installing your amplifier Aerial signal distribution 1. Connect your UHF aerial downlead to the IN SLxB TV sockets in any combination. UHF socket and connect your FM/DAB aerial If your TV does not have a built-in Freeview™ downlead (if applicable) to the IN FM socket on receiver you will need to connect your TV to the the amplifier.
- Page 3 2. Connect an aerial fly-lead from the RF2 output one of the connected TVs you will now need to on the Satellite Receiver to the ANT input on the install a Link device such as the SLx Link. amplifier. Note. To view digital terrestrial channels an aerial 3.
- Page 4 Specifications Inputs Outputs UHF Freq. VHF Freq. Max output Gain per port Noise Isolation Loss Weight Dim. mm 470-790MHz 30-300MHz 90dBµV ≤4dB 22dB 550g 175 x 85 x 46 Troubleshooting If you are experience reception problems after aerial is a wideband, high gain aerial suitable for DTT reception.