Screen Configuration; Setting The Day Of The Week And Time; Operation - Mitsubishi Electric PSA-RP·KA Operation Manual

3. Screen Configuration
Function Selection of remote
controller
Standard Control Screens
OFF
Timer Monitor
MON
TIMER
OFF
˚F˚C
WEEKLY

4. Setting the Day of the Week and Time

TIME SUN
˚C
TEMP.
MENU
BACK MONITOR/SET
PAR-21MAA CLOCK
Note:
The day and time will not appear if clock use has been dis-
abled at Function Selection of remote controller.

5. Operation

˚C
TEMP.
MENU ON/OFF
BACK MONITOR/SET DAY
PAR-21MAA CLOCK
5.1. Turning ON/OFF
<To Start Operation>
■
Press the ON/OFF button .
• The ON lamp and the display area come on.
<To Stop Operation>
■
Press the ON/OFF button again.
• The ON lamp and the display area go dark.
Note:
Even if you press the ON/OFF button immediately after shutting down the op-
eration is progress, the air conditioner will not start for about 3 minutes.
This is to prevent the internal components from being damaged.
Set Day/Time
TIME SUN
˚F˚C
˚C
ON
Timer Setup
SUN MON TUE WED THU FRI SAT
Day of the Week
& Time display
˚C
ON/OFF
ON/OFF
FILTER
DAY
CHECK TEST
OPERATION CLEAR
˚C
ON/OFF
FILTER
CHECK TEST
OPERATION
CLEAR
<Screen Types>
For details on setting the language for the remote controller display, refer
to section 8. Function Selection.
The initial language setting is English.
●
Function Selection of remote controller:
●
Set Day/Time:
●
Standard Control Screens:
●
Timer Monitor:
●
Timer Setup:
<How to change the screen>
: Hold down both the Mode button and the Timer On/Off button for 2
WEEKLY
seconds.
: Press the Timer Menu button.
: Press the Mode (Return) button.
: Press either of the Set Time buttons (
1. Press the or
2. Press the Timer On/Off (Set Day) button
* Each press advances the day shown at
Sun → Mon → ... → Fri → Sat.
3. Press the appropriate Set Time button
* As you hold the button down, the time (at
one-minute intervals, then in ten-minute intervals, and then in 1-hour
intervals.
4. After making the appropriate settings at Steps 2 and 3, press the Filter
button to lock in the values.
Set the functions and ranges available to the
remote controller (timer functions, operating
restrictions, etc.)
Set the current day of the week or time.
View and set the air conditioning system's op-
erating status
View the currently set timer (weekly timer,
simple timer, or Auto Off timer)
Set the operation of any of the timers (weekly
timer, simple timer, or Auto Off timer).
or ).
Day of the Week Setting
TIME SUN
Time Setting
Set Time button to show display
to set the day.
:
as necessary to set the time.
) will increment first in
.
5