Husqvarna 8024ST Owner's Manual page 6

INSTALL TRACTION DRIVE CONTROL ROD
The traction drive control rod has the long loop on the end
of the spring as shown.
1. Slide rubber sleeve up rod and hook end of spring into
pivot bracket with loop opening down as shown.
2. With top end of rod positioned under left side of control
panel, push rod down and insert top end of rod into hole
in drive control bracket. Secure with retainer spring.
PIVOT
BRACKET
TRACTION DRIVE
CONTROL LEVER
DRIVE
CONTROL
BRACKET
ASSEMBLY
TRACTION DRIVE
CONTROL ROD
RUBBER
SLEEVE
LOOP
OPENING
DOWN
RETAINER
SPRING
TRACTION
DRIVE
CONTROL
ROD
INSTALL AUGER CONTROL ROD
The auger control rod has the short loop on the end of the
spring as shown.
1. Slide rubber sleeve up rod and hook end of spring into
control arm with loop opening up as shown.
2. With top end of rod positioned under right side of control
panel, push down on rod and insert end of rod into hole
in auger control bracket. Secure with retainer spring.
AUGER
CONTROL
ROD
RUBBER
SLEEVE
CONTROL
ARM
AUGER
CONTROL
ROD
6
LOOP
OPENING
UP
AUGER
CONTROL
RETAINER
LEVER
SPRING
AUGER
CONTROL
BRACKET